Hire a reliable appliance service in Walthamstow

Need help disconnecting my existing washing machine and connecting a replacement washing machine in my flat in Walthamstow (E17). Scope of work: • Disconnect existing washing machine • Connect replacement washing machine to existing plumbing and power supply • Ensure machine is level and secure • Run a test cycle to check for leaks and confirm everything is working correctly The existing machine will remain in the property after disconnection, as I intend to sell it separately - if you are interested, it can be purchased for £100. Please only apply if you have experience installing washing machines and can bring any tools required. Looking to have this completed as soon as possible.

Last night my washing machine was over heating and became very hot, the fire brigade came and checked it out but was only able to unplug and avoid a fire from starting but could not diagnose the issue I am wondering if anyone is able to come and have a look and figure out what is wrong and wether it can be fixed or if I need to purchase a new one

Technogym Jog 700 needs repair/service The treadmill has been inactive for a while. I had purchased the tread mill for use at home. When turned on somes times it starts up and starts turning the belt initially but sometimes it just stops and displays: pause Resetting and then press any key to continue Sometimes the message is PAUSE: press QUICK START to restart other times i switch it on and off, then it starts working as i increase the speed it just stops again Basically it wont pick up speed and if we do manage to get it to some speed, it will then stop after some seconds.

The water level in the boiler is unable to flow upstairs due to low pressure. I've no hot water in my upstairs showers

We have an old gas fire which we’ve never used. I’m 90% sure it’s not connected to anything as we have since had a new boiler installed but it obviously needs checking. Or capping off is also fine, just needs to be made child proof.

Replace x1 radiator - same size

I am looking for a multi-skilled tradesperson (or a plumber with good carpentry skills) to install a new 45cm Bosch Integrated Slimline Dishwasher into an existing kitchen cupboard. The job involves three main parts: 1. Cabinetry/Joinery: • Remove the internal shelf and the wooden floor/base of a standard 45cm cupboard so the dishwasher can sit directly on the kitchen floor. • Cut a hole in the side of the adjacent sink cabinet for the water and waste hoses. • Mount the existing cupboard door onto the front of the new integrated dishwasher using the manufacturer's template. • Trim or adjust the existing plinth (kickplate) to allow the dishwasher door to open fully. 2. Plumbing: • Install a "Y-splitter" or a "Double Spigot" under the sink so the new dishwasher and the existing washing machine can share the same cold water feed and waste pipe. 3. Electrical: • The kitchen currently has a socket for the washing machine. I need a safe power solution for the dishwasher—either by installing a new double socket or a fused spur, as there is currently no dedicated outlet in that specific cupboard. Dimensions: • Countertop height: 85cm • Cupboard width: 45cm • Appliance: Bosch Integrated Slimline

We want to install a dishwasher next the the washing machine. Currently next to the washing machine is a cupboard with a plug socket. We would need to (1) remove the cupboard, (2) rewire the plug so that it has a double socket for the dishwasher and the washing machine & these would need to be rerouted somewhere visible - there is space by the boiler cupboard, (3) do the plumbing for the dishwasher - the waste outlet already exists, but we need an additional inlet. Note that currently the cabinet is holding up the countertop. We would also need (4) a bracket to hold the countertop, screwed into the wall. We also have a drip from the toilet (rear pipe)and the shower drips when it's in the upright position. Hopefully these are smaller jobs. The dishwasher and washing machine can be swapped around potentially. Happy to show the job if you are in the area. Let me know if I need a separate electrician for the plug. Just hoping someone would know how to do both plumbing and electrics. Let me know about the price.

Gorenje built in oven is heating then stops halfway through. Suspected thermostat fault. I need an engineer to order the part and attend to replace the thermostat

Coffe machine is tripping the main board. It appears to have an electrical fault.

Zanussi ZDT21006FA dishwasher, fully integrated built-in unit that’s stopped draining properly. Water remains in the base and does not drain. Filters and sump have been fully cleaned and checked. No blockages found. Issue is consistent with a failed drain pump. The dishwasher is fully integrated, so it will need to be pulled out to access the pump from underneath. Power and water can be isolated easily. I’m happy to buy the replacement drain pump myself in advance if needed. Someone experienced with integrated dishwashers who can replace the drain pump, refit the unit, and test for correct operation and leaks. Thanks!

About 10 minutes into a washing machine cycle, the machine fills up with water, but then stops and flashes an E10 error code. I am able to drain the machine and have cleaned the front filter, but when I tried again to do a hot wash cycle, it stopped after 10 mins again. I’m not sure if it’s an issue with the drum, or the inlet hose.

Hi, Washing machine is blocked on E03 even after cleaning the filter. Need a professional to fix it. Thanks for your offers!

My Miele hoover was operating great But it started to make a noise while hoovering Silent usually Then it stopped I changed the fuzes thinking that it was the fuses Do not quite understand what it is

Remove existing 2 ceiling lights and assemble and install 2 new ceiling lights - picture below. We have a discount code DUNELM15 for £15 off our first task

Dishwasher has a cover and something has broken so it no longer a stays attached. And we need help reattaching it. There s not an issue with the dishwasher Additionally, we also have a small picture frame that we could do with help putting up into a brick wall.

Beko DTLCE80021W condenser dryer (2022) – water tank / pump issue The dryer heats up and dries fine, but partway through the cycle it starts flashing that the water tank is full, even though it’s completely empty. I’ve cleaned the filter, condenser, and all the pipework, and checked for any lint blockages. I also manually lifted the float switch in the sump — it moves freely, but the pump doesn’t kick in to move the water up to the main tank. Seems like the pump isn’t being triggered

I have had a new kitchen fitted and I need a gas engineer to install a gas cooker to an existing inlet. The cooker inlet does not line up exactly with the existing one so may need a pipe or something to attach it properly

The water has been drained but we get this error message

My washing machine isn’t draining water. It’s a hotpoint!