Find experienced local tradies in Sydney Eastern Suburbs

I currently have a wall (not big at all) which I am wanting cut out and shaped into an arch shape. The reason for this is natural light needs to come through to the room.

Need to make 2 main holes 450x450 in gyprock roof

Gyprock wall metal frame and door, frame, skirting and cornice

A new switchboard has recently been installed in my entrance hall, leaving two sections of the wall requiring repair. The work involves filling holes, patching plaster defects, and painting the areas to match the existing wall. The two sections measure approximately: 43cm x 15cm 40cm x 50cm Plus one small defect about 4x3cm See photos. Scope of work: Prepare the surface and fill any holes or gaps around the new switchboard casing. Patch and sand the plaster to ensure a smooth, flush finish with the rest of the wall. Apply a primer/undercoat if necessary. Paint the repaired sections. I have the matching paint ready to use, but please bring your own brushes, rollers, and drop sheets to protect the floor.

Want to create a room by closing off an area with two gyprock walls with a door and frame, skirting and cornice

My salon ceiling has water damage and a small section around a downlight that has cracked. The ceiling will likely need the damaged plasterboard cut out, replaced, patched and made ready for painting. Photos attached. Ideally someone who has experience with ceiling repairs and downlights. The leak has already been resolved but the ceiling now needs repair. Location: Paddington. Please quote including materials if possible. We have the paint available on site.

Bedroom wardrobe sliding door runner/wheel broken and removed. Have replacement but requires installation.

Plastering for some ceiling and walls for an apartment. We have the existing cornices

I need a power point put in in my hallway! There is one on the other side of the wall so it should just be a matter of connecting through to that one

I need to mount a base for an indoor clothesline, but the area where it needs to mounted has been patched before and isn't strong enough to hold it. I need a new piece of plasterboard about 300mm x 300mm to be inserted with some internal backing to serve as an anchor. Unfortunately are no internal studs in the area around where this is going to be mounted.

Complete the final touches to installing an outdoor sauna

Need a simple plasterboard patched in my hallway. It either needs to patched, or cutout and patched. Hole/dent is roughly 10cm. No painting

Demolish 10m of awnings for house in rose bay. Have tools.

I have a brick wall that I need plastering/plasterboarding (this 175*145cm approx) and also a hole in the ceiling as a result of a vent that needs plastering over so it can be painted

The plastic ring hook on my crank operated awning broke. Looking for help to source a replacement and fix it.

My roller blind was mounted to a timber plank, and the plank has pulled out of the concrete ceiling near the window. The blind and timber came down together. Needs someone to: • Inspect concrete ceiling and existing holes • Install proper masonry anchors / dynabolts into concrete • Secure a new timber batten or brackets correctly • Re-mount the blind safely so it won’t fall again • Patch/fill old holes and tidy finish • Check small gap/draft near window Photos attached. Please bring tools/materials or advise what’s needed. Happy to have inspection first if unsure.

Description Need gyprock repaired and painted to match existing. Wall Repair damaged gyprock around power point and wall above, including replacing missing section, tape, set, sand, prime and paint. Power point faceplate to be removed and refitted safely. Ceiling Repair hole and crack line, tape, set, sand, prime stain block if needed and paint ceiling to blend.

Plasterboard wall repair after TV mount removal – professional finish required. I have a wall with multiple old TV mount holes, metal anchors, and a cable chase opening. I need: • All metal anchors removed • Damaged plasterboard cut back cleanly • New plasterboard patches installed with backing • Joints taped, skim coated, sanded flat • Entire wall repainted to match existing finish This is not a filler-only job — it must be done properly so the wall is perfectly flat and invisible after painting. I also want all cables hidden behind the wall Please quote including materials and paint.

We are looking to hang a round mirror onto a plasterboard wall. The mirror is not glass, but it has a metal frame so is heavier than something you might get at Ikea etc. Looking for someone who can hang it properly, using the appropriate fixings, not make a mess, etc. And takes pride in their work.

I need my 2 person infrared sauna de-assembled and then re-assembled into my gym at home. On the same property…literally in front garage and then into back pool house/gym