Find experienced local tradies in Brisbane

Besser blocks walls to be rendered as per photos before fencing is installed

10mm aquacheck board to be installed in 2 x small locations (approx 250 x 250mm) around mixer and tap rough-in. Any joints to be taped and set (no sanding required).

Pergola shutters motor is running but blades not moving 360 degrees round. Need to have someone who knows mortised awnings carry out repair.

Looking for a reasonably priced Renderer to render an outdoor fence . Builder will provide rendering materials.

Remove and replace the window awnings (4no.) Zincalume sheeting

Painter wanted to paint over plastering, and advice needed on what colour to match up the rest of the space as unsure what paint was previously used.

1. Approx 5 x 5 cm damage / hole to wall moving furniture 2. A smaller area where a door handle had made a dent in the plaster. Would like both areas filled so I can repaint .

looking for a handyman/ carpenter to fix wood rot on from and back deck

Repair Plasterboard Ceiling. No water damage. Easy access. Cut out damaged section neatly Install new plasterboard patch Tape and set joins Sand ready for painting Painting not required, I will paint.

I am after a painter to paint balustrade Timbers before I cut and install them. And also paint already installed balustrade, I have already got a coat on the installed Timbers. $45/hr cash 8 hr day

3.3 sqm wall we had to redo waterproofing. Need to render again.

I need a professional plasterer to finish a newly built room. All gyprock is already installed on the walls and ceiling. This is a finishing job only—taping, mudding, and sanding. Room Dimensions: 2m x 4.2m with 2.4m high ceilings. Key Requirements: Square Set Finish: No cornice is being used. I need a perfectly flush, clean square finish on all wall-to-ceiling and wall-to-wall internal corners. Uneven Joins: A few boards have uneven joins (see photos) that will need a professional touch to feather out and ensure a flat surface. Full Finish: Tape and set all recessed and butt joints, external corner beads, and all screw heads. Sanding: Final sand must be paint-ready. Cleanliness: You must clean up all dust and plaster debris from the floor and site upon completion. Details: Materials: Please include the cost of all tape, base coat, and topping compound in your quote. Timing: Ready to start as soon as possible. Location: Grange Equipment: Please bring your own stools, tools, and drop sheets. A vacuum-attached sander is highly preferred to manage dust.

Need 3 holes patched and skimmed Professionals only please Need to keep the mess down and clean up after sanding. Might be easier to cut the whole section out and replace as one piece ?

Install an expandable awning on an outdoor patio. Comes in box and easy to install.

Curtain rail ripped away from the wall in master bedroom and left a roughly 6-6.5cm diameter hole in the plasterboard. 2 smaller/shallower holes in teenage son’s room, one around 3cm diameter and second around 6cm. We are looking for someone to tidily repair these holes as soon as possible, although we will not repaint at this stage.

Will require a scissor lift as being installed at a height of 4.5m. Canvas size is 6.9m x 2.5m. Two person job. Appropriate licensing required.

3D for new gate house construction

Re-hang two interior bedroom sliding doors that are off balance. Sand down (and chip away ) wooden door joint that is incorrectly sized for door frame. Drill and mount security camera on outside steel post. Small furniture lift/re-arrangement

Small block walls need rendering

I need to have a split system air-conditioning system installed along with an additional PowerPoint. The system needs to be installed by a qualified electrician who can supply a certificate of compliance. This is a new system and he’s not replacing an existing system.