Find a professional verandah installer in Brisbane

At least one Outside drain is clogged and wont drain, others will also need to be looked at and cleaned Odour inside apartment as well despite unclogging all the drains, need help!

The bottom section of veranda post has rotted as well. Veranda post is 95 x 95mm. Also a section of balustrade needs replacing consisting of a section of horizontal and vertical dowels.

We have some new batwing for doors for the top of our external stairs. We need them and their hardware installed. I have selected a rim lock with knob, cabin hooks, and panic bolt. I picked a rim lock because it is much easier to install than mortise locks so please take that into consideration when quoting.

Install a single retractable clothes line on verandah. Walls are concrete

Enclose an area of a verandah with weatherproof board. The dimensions are a few meters by a few meters and height of approx 180cm. The quote needs to include measurement and a trip to Bunnings Newstead (15 mins away). The area will be used for temporary storage and it can be a very basic job. There are only two sides that need to be inclosed, the other two sides are part of the house. Please see attached photos. The weatherproof boards will need to be painted first with paint supplied by poster. There is a triangle area at the top of one of the sides that need to be covered with mesh attached to the ceiling and the inside of one side. This mesh will need to be purchased from Bunnings and included in the offer price. It doesn't have to be perfect, this is a job for someone that is handy and can get things done. Poster has basic tools and Bunnings can cut the weatherboard panels to size. However the job is better suited to someone that has a set of basic tools for this type of task.

Hi. We have a front verandah that requires to be sanded painted. I think it is around 50 square metres. Was hoping to get it done sooner rather than later. Please reach out if you can help. Thankyou.

looking for a handyman/ carpenter to fix wood rot on from and back deck

Paint underside of front verandah on house. 2 X Coats. Approximately 2.1m X 8.5m (18m²) in Monument colour. Paint sub battens in Lexicon 1/2. Paint provided. Brushes not provided.

We would like our front and rear upstairs verandahs sanded and stained, each one is 16sqm (2m x 8m). They are in pretty good condition and need to be sanded and have a couple of coats of Intergrain natural stain. I can supply the Intergrain stain.

Wrap fairy lights around 2 under-verandah rafters. Each about 2 metres long. Job will require a ladder.

2 small panels to be cut and replaced.

Sand back and stain side and front verandah floors - each verandah is roughly 8m x 2.5m - about 3/4 is grey weathered timber which I’ve brought back before using gurney, remaining 25% is protected from elements and not that bad.

Replace 1 vertical timber paling in my railing on my deck

Restore trims to base of verandah posts where they meeting decking. Also replace fence palings.

The corner of the sail needs to be secured

I have previously sikkens the front verandah and not re-coated it in time. It now requires a light sand to remove the deteriorated sikkens product. The verandah area is about 19 square meters. I am only after a price to sand the deck.

A section approx 3.5 m need a replacement bottom rail and replacement posts

The back verandah steps down to the garden only have a banister on one side, leaving the other side exposed. This is dangerous and not to code. I need to have the other banister installed in such a way as to match the rest of the staircase. Building is a queenslander and the staircase is timber.

Airtasker 1. Remove 2x outdoor verandah light fittings. (2.5m height) 2. Replace 1x outdoor verandah light fitting. (3m height) 3. Replace 4x outdoor verandah light bulbs. (LED) 4. Wire up outdoor light fixture with 8x light fittings “Lampada Cantino” (provided) Guide wires already in place. 5. Install outdoor light fixture to structural beam with hardware provided. Supplies required: Electrical cabling as required. 4x light bulbs to suit existing fittings (GU10 LED) Ladder and tools as required.

I put a Lockwood lock on my verandah door but I can not get it to lock without leaving the key in it … fairly pointless really