Find experienced local tradies in Brisbane

Awning needs fabric replacement

Looking for a power coated white balustrade Sizing as follows - front balcony 3945mm, rear balcony 2980mm x2 & 3565mm × 2 Preference for post mount Attachments

Experienced carpenter required to repair two balustrade/handrails that have rotted on our front outdoor stairs. Materials and labour must be included. Quality hardwood must be used.

Just need couple of small holes patched for my move out . Would be about 5 small holes

Repair and paint (I will provide paint) a tennis ball sized hole in wall (drywall).

- install a new DC ceiling fan with remote that has been supplied by myself to the Living area between 2 downright (new position - no existing fixtures here). Access hatch/panel above kitchen as shown in photo. - install 3 new double power points in Study. Due to location, these will need to be run via a slim conduit as the power available is on the adjacent wall. - install a power point in the kitchen. There is existing power closeby.

Someone to sand back the whole sauna and ice bath on the outside and re-lacquer with UV protection, paint or clear and then pull off all the bitchimin shingles off the roof of sauna and reseal with new ones and all silicon. Make sure waterproof and tight. Task includes materials . must have own tools and experience .

Re my Job listing for $1,000

Need someone this week to patch the ceiling from a water leak. Gyprock will be provided. This job is for ceiling replacement and plaster only. I will be on site for most of the day today(Tuesday) if you need to view job. This needs to be done this week.

I have a hole in the ceiling of my garage that needs to be repaired/filled. It is approximately 24 cm wide by 15 cm long.

We have a 10m x 1-1.5m rendered wall on our pool where the render is bubbling and coming off. We need the bubbling fixed and patched and the whole wall repainted. Also would like the black diamond tiles removed as well. Ideally this can be done without draining the whole pool. Unsure on budget.

Finish sheeting around fireplace. Set joints. Fit cornice

Small rendering job two small sections either side of fire place (approx 2m2)

Hi, I am the owner of an apartment in Brisbane City and need a licensed electrician for two small tasks: ​1. Replace 1x Double Power Point: I have already purchased the new Hager Silhouette power point (see photo). It is a like-for-like replacement. ​2. Replace 1x Kitchen Downlight: One integrated LED downlight is out (see photo). Please provide a new LED downlight fitting and install it for me. ​IMPORTANT: The existing lights are WARM WHITE (yellowish light). Please ensure the replacement matches this color temperature exactly. ​Requirements: ​Must be a licensed electrician. ​Provide an Electrical Safety Certificate upon completion. ​Quote should be all-inclusive (labor, call-out fee, and the cost of the new Warm White LED fitting).

Repair Plasterboard Ceiling. No water damage. Easy access. Cut out damaged section neatly Install new plasterboard patch Tape and set joins Sand ready for painting Painting not required, I will paint.

I have a small hole in my plasterboard wall (about 4 inches by 4 inches) that needs to be repaired

I am after a painter to paint balustrade Timbers before I cut and install them. And also paint already installed balustrade, I have already got a coat on the installed Timbers. $45/hr cash 8 hr day

3.3 sqm wall we had to redo waterproofing. Need to render again.

I need a professional plasterer to finish a newly built room. All gyprock is already installed on the walls and ceiling. This is a finishing job only—taping, mudding, and sanding. Room Dimensions: 2m x 4.2m with 2.4m high ceilings. Key Requirements: Square Set Finish: No cornice is being used. I need a perfectly flush, clean square finish on all wall-to-ceiling and wall-to-wall internal corners. Uneven Joins: A few boards have uneven joins (see photos) that will need a professional touch to feather out and ensure a flat surface. Full Finish: Tape and set all recessed and butt joints, external corner beads, and all screw heads. Sanding: Final sand must be paint-ready. Cleanliness: You must clean up all dust and plaster debris from the floor and site upon completion. Details: Materials: Please include the cost of all tape, base coat, and topping compound in your quote. Timing: Ready to start as soon as possible. Location: Grange Equipment: Please bring your own stools, tools, and drop sheets. A vacuum-attached sander is highly preferred to manage dust.

Need 3 holes patched and skimmed Professionals only please Need to keep the mess down and clean up after sanding. Might be easier to cut the whole section out and replace as one piece ?