Find experienced local tradies in Brisbane

Install 2 x airconditioners. Each air conditioner is going onto a wall near a power point. I can supply the aircon or you can supply it. Each aircon only needs to cool/ heat a normal bedroom size 3x 3m. I have also attached a photo of the exterior wall along which the airconditioners will go. Also: Relocate modem box from lounge room to dining room. Install 5 new power points in yet to be constructed new walls Install 2 new downlights Relocate 1 light switch Remove 1 old ceiling light fitting and leave the hole ready for plastering Install a box/cover over loose cables ( see picture) Replace broken light switch where the switches have fallen into the wall Split 8 downlights lights currently operated by one switch into 2 separate switches House is single story and made of plaster walls and timber frame. There is good ceiling access and under floor access.

Plasterer Required – Jib Stopping & 90mm Cove Cornice I'm looking for an experienced plasterer to complete the plastering work for a small internal renovation in Brisbane. Scope of Work Jib stop/plaster all new plasterboard joins and internal corners. Supply and install 90mm cove cornice. Apply all required plaster coats. Sand all surfaces smooth. Leave all walls and cornices ready for painting. Wall Dimensions ( total 6 walls but both sides of wall need doing so 12 faces) Wall 1: 2.7m (H) × 3.7m (L) Wall 2: 2.7m (H) × 3.7m (L) Wall 3: 2.7m (H) × 3.7m (L) Wall 4: 2.7m (H) × 3.7m (L) Wall 5: 2.7m (H) × 2.1m (L) Wall 6: 2.7m (H) × 2.1m (L) Wall 7: 2.7m (H) × 0.9m (L) Wall 8: 2.7m (H) × 0.9m (L) Wall 9: 2.7m (H) × 1.1m (L) Wall 10: 2.7m (H) × 1.1m (L) Wall 11: 2.0m (H) × 0.9m (L) Wall 12: 2.0m (H) × 0.9m (L) The total wall area is approximately 65 m². Materials I will supply the 90mm cove cornice. Please supply all other materials required, including: Plaster compounds Cornice cement Joint tape Adhesives Sandpaper Any other consumables

Repair the rust on 5 edges of the residence. Would require sanding back and then painting.

I need an electrician to replace/fix an internal power point enclosure that has come away from the wall.

I need a new ceiling fan installed and 3 new power points

Just need a patch up in a small section in garage. Someone with plastering experience

I need a power point installed. It is right behind my outdoor power point at my townhouse so should be easy to do. Needs to be qualified electrician providing invoice .

I am needing plasterboard walls removed ASAP. Contractor needs to have insurance - this needs to be provided All tools will need to be supplied Experience doing this type of work. Needs to be able to read plans Rubbish removal to be managed by contractor Level 2 Access via lift via the basement.

Install Plasterboard Ready for Tiling – fortitude Valley Looking for an experienced plasterer or handyman to sheet two kitchen splashback walls so they’re ready for a tiler. Job includes: * Supply and install suitable plasterboard for tiling. * Cover the exposed blockwork splashback wall (approx. 3m²). * Finish joins and external corners so the surface is flat. * Cut around electrical points. * Clean up after completion. The old splashback has already been removed, so the walls are ready to be sheeted. Please provide: * Your quote (including materials). * Your availability. * Photos of similar work if available. Location: fortitude valley, Brisbane

Replace rotten lower hardwood balustrade rail only x2. Existing post is sound. Reuse existing balusters if possible. Supply matching hardwood, install, prime all cut ends. Painting not required. Price negotiable

We have just raised the height of a balustrade beside a set of external stairs through on-site steel welding. The task now is wire brush the welds to remove any rust and scale, prime all new weld joints and then to paint the balustrade black (monument). This only applies to the new, raised section of the balustrade. The photos show the that balastrad looking down and then looking up as well as a typical welded joint that need to be prepared. The photos also show the lower balustrade already painted black and needing no further work and the new upper work which has been primed grey. There is also some new infill bars in the old section shown in the photo looking up the stairs that need to be painted.

I need a hole in the plasterboard patched where a switch was removed and install two hooks to ceramic tile in shower and one towel rail to ceramic tile in bathroom. I have got stainless steel hooks to withstand the water. I also am supplying the towel shelf.

Simply a double power point installed on the weatherboard wall.

I recently had some electrical work completed and now need a professional to patch and paint the affected areas on my walls and ceilings. Details: Scope: Professional patching of holes/chases and repainting. Materials: I do not have usable paint, so please include the cost of all materials (patching compound, paint matching, brushes, etc.) in your quote. Timeline: I am looking to have this completed as soon as possible this week. Please provide a total quote inclusive of labour and materials. Let me know your earliest availability to start. Feel free to reach out if you need photos of the areas or have any questions. Thanks!

Need an additional power point installed in a top cupboard in a double storey home in camp hill

Fix plaster wall around power point.

Needing a qualified renderer to help out for a day or two. Must have own tools and attention to detail is a must as it’s high end work.

Experienced carpenter required to repair two balustrade/handrails that have rotted on our front outdoor stairs. Materials and labour must be included. Quality hardwood must be used.

Need someone this week to patch the ceiling from a water leak. Gyprock will be provided. This job is for ceiling replacement and plaster only. I will be on site for most of the day today(Tuesday) if you need to view job. This needs to be done this week.