Find an experienced local handyman in Koondoola

Need lockable door handle set installed. Door hanging. Will need to drill a new hole to fit new replacement lock set. I have the new lock set already. Payment negotiable.

Need to fix the wall with tile and wooden pieces ( tap removed area)

Screen is broken Hitachi led

Hey there, my name is Cathy. I need to hire a handyperson to help me in Koondoola WA 6064, Australia. What do you need done? Repairs What is the type of property? House Which areas of the property need work? Front windows What would you like the handyperson to work on? Repair Wooden two window frames

Rollers needs replacing and track I think

Removal of old and installation of new clothesline

Hi I got two reticulation points damaged Please help me to fix

we need a bathroom door opening outside from bathroom

This job has 2 elements. 1. Bathroom renovation 2. Hallway, laundry and toilet retiling and toilet installation 1. Bathroom renovation: - Remove and dispose of existing material - Retile bathroom floor and wall (to ceiling) and install: * Shower * Assemble and install vanity * Toilet - cistern in wall toilet * Spa bath *Cabinet with mirror * Other small fixtures - towel racks etc I have or will purchase all components. I have attached pictures and a schematic. The room is 2550 mm x 1780 mm The shower will be 900x900 or less (am yet to purchase, will look for smaller) The vanity is 1030x490x640 This leaves 620 or slightly more for the toilet. I will need some advice on what type of toilet to buy. I would like one with the cistern in the wall (the wall is internal brick wall) The spa, situated on the other side is 1300x680 This leaves approximately 610 between the spa and the vanity. It will be a tight fit but a toilet with cistern in the wall will work. The bid should include plumbing (and electrical if possible although I can source this) There is also a window next to the proposed toilet that needs replacing. If the bid could include that it would save the trouble of getting it done separately. The window is 1500 x 800 and is a regular sliding bathroom window - frosted glass 2. Hallway, laundry and toilet The hallway is 5700 x 1000 (at widest point) The laundry is 2800 x 1250 (at widest point) All tiles will need to be removed and new tiles laid. The laundry was recently renovated over the existing tiles To install the new tiles, kickboards and a side panel will need to be removed and put back (making the job much easier) and care will need to be taken not to damage the renovations - tiling can be done up to the support legs - I have attached pictures - this will also need to be done with the cupboard on the other side. Tiling in the hallway and laundry will need to be done with skirting The toilet area is 850 x 1500 x 2300 (high) and will need floor tiling and wall tiling from floor to ceiling. A new toilet will need to be installed in place of the old toilet, but it should just be a new for old installation

I have treadmill few years no used than today has everything power no start

I need the taps fix ASAP there is on in the kitchen and one in the bathroom. And I need my Security windows seal cause that came out

Sliding door not working the door hinge pulled away

Hi We have a new bathroom that we have had a shower installed as per the pic Problem Is it’s too big for the shower cubicle and we want to replace with a hand held shower that slides up and down with a single rail as pictured which is a simpler setup from the one we have Would like it done by a licensed plumber please We may be able to use one or 2 of the existing drill holes, but understand you may need to drill additional holes and we can fill existing holes with silicon or similar Today also or 24/10 is also possible either early or late in the day

Need to fix the hole behind the kitchen sink. I have the tiles

Nearly 9 metres of drain channels installed and raised edging to go behind it as the sample pic shown, one drain will need to be cut to measure final bit (drain is plastic) Need it to sit on concrete bed and the edging also to sit in the concrete so they stay upright The bull nose edging shown can be sitting next to each other and do not need to have mortar between them Minimal digging required for drains etc.. as I have already removed a lot of soil Need drain connected to soak well already installed that already has pipe sticking out of ground I already have storm drain connectors / different angles etc.. and pipe glue You will need to supply a saw to cut a couple of the edging blocks to size and also possibly mitre the edges for a 1 x 90 degree join You will also need to supply concrete and mixer (can pay seperate for concrete or have on site before you come) I’ll also have yellow sand here as well ready to use I’ll also supply silicon Looking to get done ASAP the date supplied on this post is flexible Make an offer if you want Cheers

After someone to hang a front door and install new lock and touch up the frame work looking for a free quote so you can see the job first

Hi, i need to install 4 x blinds for my patio area(outdoor)? If i buy bistro blinds and material can you install them? Rough measurements 210cm drop x 280cm width. cheers Vin

To fix the tap and seal The security window that have came out from the windows

My current neutral meter link on my electrical switchboard has 7 holes, looking to get it replaced with a bigger one as I have recently installed an air conditioner and there isn’t enough holes.

Old house located in koondoola needed window flyscreen repair. No equipment nor materials provided.