Find an experienced handyman in Glebe NSW

Looking to have a damaged section of gyprock cut out and new gyprock installed inside my bedroom storage cupboard (sorry for my terrible photo! But it is the bottom corner). All materials and tools to be supplied by the AirTasker

I would like someone to buy and hang 2 internal doors at my unit in Glebe. The doors are 810 wide and between 2215 to 2200 tall.

Mount two IKEA ‘Lack’ shelves on brick wall (we already have correct screws and anchors if needed) and a coat rack in the hall (needs screws). All brick walls so will need a hammer drill etc.

The removal of a burn mark on the kitchen bench and would like the surface restored back to its original color.

Need help from experienced carpenter to figure out how to remove this fixture from wall. I have removed all the screws but fixture is still firmly attached to wall. I believed it may have nails embedded in it securing it to wall. After removal, help to load onto car. Fixture is MDF so it is heavy, I think it requires at least 2 persons to remove it.

Handyman required to attach two hooks on to external brick wall. Will probably need self tapping screws or masonry nails. This is about level with first floor window so will be better to have a ladder.

Bathroom: install shower rail to wall. Towel rack/rail to wall, floating shelf. Laundry: install shelf above sink. Kitchen: install peg board to wall. Wall surface is concrete rendered brick, circa 1980 apartment.

(Task reposted as requirements changed) Install a floating shelf on concrete wall in living area above tv. See pic. I would like it to be completed tomorrow Wednesday after lunch time, if not then Friday afternoon.

Meed a gyprock wall floor to ceiling

Fill and cover the holes that a subletter drilled into the walls of her room + need colour to match

We removed a picture hook that was not meant to leave a mark in the wall but it did. The hole needs patching up and painting.

Scope of Works Level 3 Structural Installation and Roofing Extension Project Installation of pre-fabricated steel structure Location Level 3 Commercial Terms Fixed price contract capped at fifty thousand dollars No variations or cost overruns will be accepted Required Qualification Builder must hold a valid Class 2 Builders Licence and provide certification at completion Project Overview The steel structure has already been fabricated and is currently stored in the garage. The builder is not responsible for fabrication. The builder is responsible for transport within the building, installation, fixing, roofing extension, drainage, finishing, compliance and handover.

I need three curtain rods installed in a bedroom, living room and dining room — these two would be over a sliding door frame. I have already pre purchased the curtain rods that can be used during the construction process. I also need help fixing a single step on my staircase that has gone loose.

I have 16ft ceilings and need two ceiling fans (already purchased) with extender poles (already purchased) to be installed in the bedrooms above two beds. Existing light fixtures in place, to be replaced. Remote control operated.

Have an existing Dincel wall that has been coated with Acrylic render. Need to repair the coating on a patch 2m by 2m . Banboo got in behind te rende ran levered off the patch. The rest of the wall is OK.

I have a terrace house in Glebe and need a few small repairs done. I’m hoping to get the work completed before the end of January. I’m looking for an experienced handyman. Rates are negotiable, so please feel free to submit your quote. The work includes: One of the front wooden door locks is broken. It may need parts reinstalled or a new lock. There is also some minor timber damage around the lock area. A few timber floorboards near the front entrance are damaged and need replacing. To make things easier, I’m happy to purchase the required materials from Bunnings based on your advice, to save time. Photos of the areas needing repair are attached. If you’re interested or would like to discuss further, please message me via Airtasker. Thanks! Stephen

Looking to have 3x new power points installed. They’re both plaster walls. Please refer to the photos for details.

Handyman work for reasonable price

Install blocking between joists for ceiling fan hanging, and install approx 200mm dia blocking in centre of ceiling rose. Use appropriate treated pine

Install 2 ceiling fans with light. We have one already done, we want to add 2 rooms to do the same thing (see photos).