Hire an affordable Carpenter for any job in Enmore

While renovating bathroom we’ve found some internal studs have rotted at the bottom. Rotted timber needs to be replaced and gyprock in the adjoining room needs to be resheeted. Gyprock area is approx 2000mm x 1000mm. Horizontal timber piece is 1300mm long and 3 x vertical pieces 400mm long. Minor job. Photos attached. Carpentry skills required.

Cut 4 x 3mm melamine MDF boards time custom size using a circular saw to prevent chipping (provided by you) I can drop off and pick up boards if required (to be negotiated) Twelve hundred x six hundred x three millimetres. To be cut to nine hundred and fifty x two hundred and ninety x three millimetres.

Basic outdoor cupboard build, melamine. Approx 160cm wide with 2 doors approx 160cm tall to match top cupboards in photograph. The doors are hinged in 2 areas as illustrated in photo. Preference to have 3 internal removable shelves. Estimate is 4 - 6 hours work. Cost of Materials to be covered outside of hourly rate, of course!

the deck is [Content Moderated] it is a Queensland spotted gum

Build a heavy duty shelf in an Enmore Cafe - Shelf needs to be approx 4000x500 - Made from form ply (I have the materials for this part) - Fixed to Masonry walls - Must be done after 3pm on a weekday Might be best to build a frame and then lay the form ply on-top rather than use brackets, but open to suggestions on this.

Looking for someone to build a cupboard into a cavity in our bathroom. There is currently a cupboard there that will need to be removed. We can pay for materials after purchase if you can please quote for the job. Thanks

Hey there, I need an experience person prefer someone with an insurance to Cut external masonry wall, install steel beam and bifold doors. Will supply doors. Must be to come and Inspect, give feedback prior starting the job. SORRY NO TIME WASTERS We can only allow a week for the Job to be COMPLETED

We'd like a small wooden deck, about 2m x 3m, built. It's a pretty easy job, it will need to sit level over some existing brick pavers and a bit onto a small part of the lawn, & single level. We'd need you to obtain the wood too. Amount I've given excludes the wood. Also need you to paint/seal the undersides, we can do the upper parts.

Removal of various wood panels that used to be a built in wardrobe

Need new walk in freezer to be built approx 1.5m x 1.8m x standard height. Want total price with new motor connected etc.....

Outdoor dining table is 3m x 1m (extended) and includes 8 chairs (only top of table and arms of chairs are timber - pics can be provided). Needs 2 coats. Timber Bar is small (1.2m x 30cm) spotted gum. Needs to be sanded back and re-stained - pics can be provided

Bought a 3m pool off eBay, is good quality & needs assembly by someone good on the tools. Should only take a few hours, needs to done on Thursday 7th November or before. Needs to be setup in the correct space via measurements as a pool fence will be installed around it after

Looking for a chippy / carpenter for a small job to plane 2 timber internal doors, as carpet is being installed and require adjusting. One of the doors requires re-hanging to the alternate side of the door frame. Estimation is 2 hours work.

Easy shed - 1.5m x 2.2m Concrete base already ready made

Looking for a carpenter to attach skirtings, architraves, door jams and hang doors asap on hourly rate

Need to extend an existing coolroom by 1.8 metres. The width is about 1.5m and height is about 2.2m

Need help to unscrew a wooden wall bench that’s 2.3m long with 3 brackets on the wall and take the brackets off the bench. Also need to saw the bench in half. It’s 4.5cm thick wood bench.

Build bench on the wall to cover the pipe

I have several paint jobs around the house including deck, one indoor and two outdoor walls and concrete. All paint provided. Estimated 2-3 days work

Remove red wine stains from approximately 1m3 of polished concrete. Enmore.