Find experienced local tradies in Beaumaris VIC

There are 3 small areas requiring plastering repair. 1 after water damage. 1 after air con install. 1 after mattress fell into wall. Thanks

A damaged part of the garage wall, needs plaster repair and painting on top, although I can paint it myself if a second visit is required

Paint outdoor balcony balustrade approx 15 meters long. Paint provided.

Stop up, sand and finish final stage of study nook. 1600 x 2300.

outdoor power outlet to be installed

I am moving 4 downlights amd 2 pendant lights to a new position and need to patch holes left from previous positions. Also prepare kitchen walls for painting. No photos until the electrician has moved lights on Saturday.

I need a plasterer and painter to repair ceiling plaster and cornice and paint entire room ceiling and entry ceiling

Hole in plasterboard wall needs to be repaired and repainted as per picture

We had a dodgy tradie poorly mount our computer monitor to the wall. I’ve taken the monitor off and the hole has basically collapsed. Need this to be patched so the monitor can be put back on the wall.

Take out a tree from a planter box repair planter made from bricks and rerender

Need a small section of block retaining wall (approx 400mm x 400mm) rendered. I can supply top coat render

Need an approx 400mm x 400mm block wall rendered and painted (I can supply render and paint)

Need a small block wall (approx 400mm high) cut with concrete saw and broken out. Will pay extra if you can render and repaint (have render and paint available).

Few areas of damaged render. Requires patching and painting.

Hi we are needing a plasterer for a day rate one day. Needing to get this done tomorrow. Base and top plaster joins etc for a bathroom renovation.

My home salon ceiling plaster and down lights

Ceiling plaster repair and paint. Cracks and filling, then sanding and painting.

19m x14m rendered brick fence. Corner block 2m height on main 19m side Lower height on side street

Wall plastering of bedroom wall

Hi there! This should be a fairly simple task for an electrician, as all we need is the movement of some existing power points at our place. Essentially moving these from being at around eye level - closer down towards the floor, to be more out of the way given the devices being plugged in are on the floor. I’ve attached an example photo, we would be needing this same task done in two rooms with power points higher up than we’d prefer. Additional (only if possible) - we would also just require the previous holes where the power points are currently situated, to be filled in / plastered over to complete the job. Yet if this needs to be done separately that’s fine. Thanks, Dave