Find experienced local tradies in Baulkham Hills

Hi, I’m looking for a licensed electrician to supply and install 1 x 15A power point in my garage for EV charging. The proposed location is marked in the attached photo. The switchboard is immediately outside the same brick wall, very close to the proposed socket location, so the cable run should be relatively short. Requirements: * Licensed electrician only * Supply and install 1 x 15A GPO * Dedicated circuit with appropriate protection * Supply all materials and cabling Location: Baulkham Hills NSW 2153 Photos of the garage, proposed socket location and switchboard are attached.

Fully experience renderer to join the team from sand and cement to all types of acrylic rendering finishes

Fully experienced renderer needed

Looking for an experienced renderer to render the front of my house – first level only. Please provide a quote including labour and materials. Measurements are below: You can amend your quote based on measurements

I need a renderer start asap tomorrow

Patch few opened Gyprock areas to fix some plumbing issue

Hi, I'm looking for a qualified plasterer to provide a quote for repairing my plasterboard ceiling following a recent air conditioning installation. The work required includes: Repair damaged plasterboard (gyprock) ceiling. Patch and plaster all affected areas. Repaint the repaired ceiling to match the existing finish. Repair approximately two ceiling openings/access points left after the installation. Ensure the work area is protected and cleaned upon completion. Please provide: A fixed-price quote (including GST). Your earliest availability. Confirmation that you are licensed and insured. Any warranty offered on the workmanship. I've attached photos of the damage for your reference. Thank you, and I look forward to your quote.

Need to fix gyprock patching and repaint

The plasterboard on the ceiling has a small section with mould. I require for you to first determine if the mould is caused by condensation or by a water leak, and second to clean / repair the plasterboard. I'm including 2 pictures: one of them is close-up.

about 2 meters from existing power point

Install water proof power points for smart toilets

Commercial Unit - unit recently painted. Agent unhappy with some of the gyprock patching (screw holes, etc) - looking for a professional to patch and repaint these areas. Paint provided.

I need a licensed electrician to install a power point under the kitchen bench inside the cabinet for my gas cooktop. The lead is already inside the cabinet. There is a power point on top of the bench which is likely where a new one needs to be pulled from. I’ve attached some pics. Happy to share more if required.

Seek qualified tiler quote to apply Stellmann P4 non-slip clear according to manufacturers instructions to newly laid residence front verandah tiles. Approx 15sq m. I have purchased product and the task ready to go.

Need some wholes patched up within a rental apartment 3 small patches and 1 large patch There is other attempted patch ups which can be seen on site to see if it can be fixed

Replace the fabric for the existing awnings and/or install 2 new ones

What needs to be done: I have 3 plasterboard/drywall holes in my study nook that need to be properly patched and made good. The holes are a mix of sizes (two small to one large hole). This is a completion job — a previous tradie left the work unfinished. Patch only required — no painting needed. Scope of work: ∙ Inspect all 3 holes ∙ Patch and fill using appropriate method for each hole size (mesh patch, backing board, or filler as needed) ∙ Sand flush and smooth to a clean finish ready for painting at a later date ∙ Clean up on completion

Need one side of cut wall rendered as per photos

Labour required to install.

Roughly 400x400 area of water damaged ceiling that is cracked and sagging after upstairs water leak. Centred in between beams.