Find an experienced plumber in Baulkham Hills

Need to fix up a new sink and connect- sink has already been installed Also there is an aircond pipe poking out which needs to be connected to work out the drainage

Replace current 160litre Rheem Stellar with a similar Rheem unit and necessary fittings etc

Remove and replace 3 back-to-wall toilet suites. Existing: Wetdesign LUCI BTW Suite Replacement: 3 × Argent Evoke SBTW200 Smart Toilets (supplied) Existing setup Bathrooms are fully tiled floor-to-ceiling, so avoiding visible tile damage is important. Existing toilets have concealed rear-entry water connections with no visible tap or hose. Existing water outlet: - Centre approx. 750–755 mm AFFL - Existing drawing indicates approx. 65 mm horizontal offset from toilet centreline Argent Evoke requirements Manufacturer set-out: - Water inlet centre: 775 mm AFFL - 95 mm from toilet centreline - ½" BSP wall elbow - Rear-entry water supply Therefore, existing outlets may need repositioning approx. 20–25 mm vertically and ~30 mm horizontally, subject to site measurement. Scope Please quote to: - Remove and dispose of 3 existing LUCI toilets - Check existing water/waste set-outs - Reposition concealed water outlets to Argent specifications if required - Install 3 × Argent Evoke SBTW200 - Connect water/waste and required valves/fittings - Secure, silicone and leak-test - Test flushing and smart bidet functions - Leave areas clean IMPORTANT – Tiles & concealed plumbing Existing LUCI toilets are approx. 800 mm high and new Argent toilets approx. 850 mm high. If wall access is required, I prefer any tile/wall opening to be within the area completely covered by the new toilet/cistern. Finished installation must have: NO visible isolation tap NO visible braided hose/pipe NO visible tile cuts or repairs Any concealed isolation/service arrangement must remain compliant and appropriately accessible. I prefer the water outlets to be properly repositioned to manufacturer set-out, rather than using an exposed workaround. Coordination of install with my electrician is required. Please confirm: 1. Plumbing licence and BTW/rear-entry toilet experience 2. Ability to reposition concealed water outlets 3. Ability to minimise disturbance to floor-to-ceiling tiles 4. Disposal of old toilets

we have a hot water tank in roof and its leaking should be fixed

I purchased a bidet but need help installing it correctly to my toilet. My boyfriend tried but don’t think we have the right pipes/tools/accessories to connect the cistern.

Supply and install S and P toilet bowl

Move hot water from controlled load to main load and remove controlled load connection. I have got a FoxEss CQ6 inverter and battery plus solar and hence I am looking to get rid of controlled load.

Hot water system installation

Have purchased the new tap. Just need installating

Toilet blocked. In a sport centre need to be fix before 11 today

Water is not connected in laundry sink

I have bought an electric bidet seat. I need a plumber to install and connect to water point.

When the taps are turned off the shower head still drips water, need a plumber to take a look and fix. Please let me know cost depending on job

Hot water tank, which runs on electricity has stopped working. Switch tripped and even after resetting, it still does not work Hot water pipe also seems cold

Replace 2 tap. Replace washer in one tap.

Install Timer for Electric Hot Water System Location: Baulkham Hills, NSW I have a Rheem electric storage hot water system that is connected directly to the switchboard on a dedicated circuit. I recently installed a solar and battery system and would like to optimise my energy usage by running the hot water system only during specific daytime hours (preferably when solar production is high). Scope of work: • Inspect existing hot water circuit and switchboard setup. • Supply and install a suitable timer (mechanical, digital, or smart timer – please advise best option). • Ensure installation complies with Australian electrical standards. • Test operation and explain how to adjust the schedule if required. Please include in your offer: • Whether you are a licensed electrician. • What type of timer/controller you propose to install. • Whether the timer is included in your quoted price. • Any warranty on workmanship and parts. Photos of the switchboard and hot water system can be provided upon request.

Looking for a plumber to give me an exact quote for this request. I would like to renovate bathroom with attached photo. I have a toilet in the same location and just want to rotate it Vanity is in the same location with cold water. Hot water needs to be added hot water is very close to vanity. Adding cold and hot water for shower and one swage for shower and one swage for bathroom. Give me the final quote just for plumbing works 20cm is available underneath the house.

Install of 900mm vanity. All plumbing and waste locations to remain the same. Supply new flex hoses and pvc pipes.

the toilet has gotten clogged.

Site Fence is open. Need a temporary tap installed on the mains, no need for back flow prevention as it’s just a temporary tap for the final fit off to be done later