Find experienced local tradies in Balmain

1) Come in person to assess the situation properly, or just ask for additional photos if enough. 2) Agree on the exact specs of parts to be used for the job. I can then source them. 3) Do the job: replace the existing handrails, banisters and bottom rails with the new ones. The load-bearing posts are not getting replaced. Total length of handrail to replace: about 5m - same length for the bottom rail.

Luxaflex Somfy outdoor awning not responsive to remote. Need help with resetting the motor

I would like someone to construct a small awning / pergola down the narrow side of my house to store my bikes out of the rain. The structure would need to attach to the side of the house. The long side of the awning would be attaching to a modern Hardie plank weatherboard clad wall, whereas the short side would need to attach to double brick. In the diagram below, the res depicts the structure I'm requesting to be built. Dimensions would be 5.2m by 0.9m. It would need to attach to the house at about 1.9m above the ground with a gentle slope so the rain could run off (no need for a gutter). So likely to need brackets and some support frames to then hold up something like a Suntuf polycarbonate clear plastic roofing. Please see photos of the area in question and aerial sketch. I would be keen for someone to inspect the site so we can discuss best design & materials before purchasing the materials. The main discussion points is probably whether it would require a support post at the near end. Im happy to either purchased myself or you can, but either way I will fund the materials so please don't include those in your quote.

Removal (and disposal) of old built in wardrobe. Place and patch gyprock in ceiling where wardrobe frame is removed.

We have the blind but need to screw in 3 supporting hooks for blind to hang

Garden bed walls and garage walls to be rendered with a “speckle” render. This is a coarse type of render that is normally splattered on with a machine. Also called roughcast or pebbledash render.

Outdoor awning needs to have a canvas patch applied to tears being caused by the rollers. I will supply adhesive canvas patch. The awning rollers will need to be unbolted & repositioned as well. Need someone who is familiar with awning repairs

We will have about 4-5 inflatables to be installed on top of an awning. It needs to be fastened

I have 2x 85 inch TV's and a 65 inch TV to be mounted in 3 gyprock walls

The electrical motor does not work

Gyprock first then plaster areas to a good finish: 1.wall area with water damage approx 200 x30 cm Photo below shows black strip covering water damage. There are also shots without the black cover for you to view 2. Ceiling about 200 x25 cm strip - from corner to about 200 above curtain rail flush to window frame 3. Behind air con unit cover needs plastering hole where cartridge was. Cartridge already removed. The cover in place temporarily. Cut out existing gyprock, replace with new, plaster and sanding exclude painting.

Hole in ceiling after air con replacement (1000mm x 1500mm) needs gyprock and painting and vent reinstalled.

Add curved plaster to finish off edge of kitchen joinery with a soft curve Have tried to create an AI image of it

Isolate 2 light fittings. Delete 2 light fittings. Isolate a light switch and power point.

The bottom third of the post is badly damaged but the whole post will need to be replaced along with the external cladding and the internal gyprock. We can organise the gyprock separately if necessary. We discovered the problem when we replaced the concertina doors. Post can be replaced without removing the doors. Essential to find the source of the leak and rectify it. Price is negotiable.

Need this sign put up (in highlighted area in image) It’s in 3 pieces It will need to be done during an off peak time due to it being close to the road Must be insured Pictures attached No signage disposal needed

Build Timber Verandah Deck Over Existing Front Porch We’re looking for a skilled carpenter or experienced handyman to help us build a small timber verandah deck over an existing concrete/pebble-dash front porch at our home in Birchgrove. The job includes: • Installing timber decking boards over the current slab • Fixing decorative timber verandah posts and brackets (we will supply or can source with you) • Ensuring level, secure fixings and a neat, traditional finish This is a light reinstatement project in keeping with heritage homes — we’re aiming for a simple Federation-style verandah to improve the home’s front elevation. We can assist onsite and will cover materials. Location: Birchgrove, NSW Access: Easy street parking Timing: Flexible over the next few weeks Please share your experience with decking/verandahs and availability. Photos of previous work appreciated!

Gyprock patching of the area in the photo. Dimensions approximately 130cm 55cm. This has to be done with the needed framing to support the gyprock.

42 metres of render needed 8 metres of which are outside. All materials supplied

Hello ! Looking for someone to cover the existing balustrade or replace it to look like this one. We had this installed in November last year and it is so ugly and unfinished. I have a reference of what we have and what we are thinking we need.