Find trusted local electricians in Balmain

Need 2 ceiling fans installed

Wiring issue while painting and house electricity has shorted. Need electrician. Only quote if available today please . Prefer hourly quote.

Wires shorted while doing paint job. Require electrician to tidy wiring so we can plaster over it. Must be today. Quote hourly only.

Looking for a licensed electrician to remove the existing pendant light and install a new pendant in the same location. New pendant and globe already supplied. Existing wiring/ceiling point to be reused. Straightforward swap — photos attached. Flexible with timing.

I have a marble base lamp that has a blown fuse. The lamp is wired through the stand and connect down through the marble base. I require an electrician to repair/replace the electrical fuses to make the lamp operation again.

Reinstall a Flos light fitting. I removed it for cleaning and can’t figure out to reinstall. It have the ladders, and link to instructions. https://dam.flos.net/damflos/products/DECORATIVE/DECORATIVE_SUSPENSION_GLO-BALL/F3010061/Mounting_Instruction_GLO_BALL_S_34295.pdf

I would like to check that this loose PowerPoint fitting is safe and if possible, have it rewired so that it comes flush from the wall and not attached to the wall like this. I would also like to remove the old telephone (I think that’s what it is) outlet next to it.

Replace 2 outdoor lights with exactly the same light

Replace existing exterior light fitting with a ring camera floodlight. Mount ring front doorbell (battery model - no electrical required) into brick adjacent to front door. Must provide certificate of compliance for the light installation.

Need x3 800x800mm skylights installed at Balmain. This skylights are on the first floor level with good access to roof from second floor balcony. Changing skylight to Velux/keylite double glazed glass skylights Works include - • Removal of x3 old defected skylights as requested • Supply and install of x3 new fixed velux/keylite double glazed glass skylights. Closest size to 800x800mm. Two skylights are fixed close the third needs to be the opening variety. • Supply and installation of custom made back trays to go behind new skylights once installed • Supply of all trade related fixings and sealants • Seal gyproc to existing gyprock • Removal of all trade related waste from site

Install 4 ceiling fans in an apartment to existing ceiling lights

Looking for a licensed electrician to replace a faulty B22 light fitting in my rental property in Balmain. The internal B22 insert cracked while changing a bulb. When removing it, the circuit breaker tripped. The internal contact appears burnt/exposed. Job required: • Supply and install new compliant B22 batten holder (or advise if full fitting replacement required) • Inspect wiring for damage • Test circuit and ensure safe operation Power will be turned off at the breaker before arrival. Please confirm: • NSW electrical licence number • Availability • Total price including parts Should be a quick job for someone qualified.

I need these light switches replaced. I have new ones from trade co so it’s just an easy swap over.

Backyard with 6 Lillypilli trees

I have two used Powerwall 2 batteries sitting on my front deck ready to be installed. The job: Remove current battery (tiny 3kwh Alpha) and replace with two PW2 with a new gateway. GW and PW2s are within 1m of where they need to be installed.

I have two light fittings that I need hung, currently it’s just one bulb hanging from the ceiling rose that the builder left there

Hello, There’s a slight change to the scope of work. Work – 1. Outdoor Lights Replace the three existing plastic outdoor lights with chrome fittings. I have purchased the following: • SAL Bondi SE7122TC/24 Series Exterior Wall Lights. 2. Garage Tube Lights Replace the two existing garage tube lights with longer warm-white tube lights. I have purchased the following: • SAL Ecoline SL9738-TC-DP2 LED Wide Body Diffused Batten. 3. Garage Switch & Power Outlets Move the existing garage light switch from the far wall to the entry doorway, and install a new double power outlet next to the relocated switch. At the original light switch location, please change the powerpoint plate so all three outlets match. Please supply: • 1 × Clipsal Iconic light switch • 2 × Clipsal Iconic double power outlets This will require conduit and a mounting block. 4. Garage Door Cable Tidy and secure the garage door cable along the ceiling and enclose it neatly in conduit. --- Materials to include – • 1 × Clipsal Iconic light switch (Point 3) • 2 × Clipsal Iconic double power outlets (Point 3) • Conduit (Points 3 and 4)

One light is missing a clip on one side and won’t stay in the ceiling. The other late also won’t stay in but has 2 clips. Both fall out after a few minutes

1. Outdoor Lights Replace the three existing plastic outdoor lights with chrome fittings. I’ll purchase these lights: SAL Bondi SE7122TC/24 Series Exterior Wall Lights. 2. Outdoor Power Outlet Replace the yellowed outdoor power outlet cover with a new fitting. Please supply and install the following: Clipsal Iconic Outdoor Twin Switched Socket (O3025-XW). 3. Garage Tube Lights Replace the two existing garage tube lights with longer warm-white tube lights. I will purchase these: SAL Ecoline SL9738-TC-DP2 LED Wide Body Diffused Batten. 4. Garage Switch & Power Outlets Relocate the existing garage light switch from the far wall to the entry doorway, and add a new double power outlet next to the relocated switch. At the original light switch location, replace the existing powerpoint plate so all three fittings match. Please supply one Clipsal Iconic light switch and two Clipsal Iconic double powerpoints. 5. Garage Door Cable Tidy and secure the garage door cable along the ceiling, enclosing it neatly in conduit. --- For your quote: Please provide labour costs. Please include the cost of materials, specifically: One Clipsal Iconic outdoor powerpoint (Point 2) One Clipsal Iconic garage light switch (Point 4) Two Clipsal Iconic garage powerpoints (Point 4)

Remove existing air conditioner. Supply and Install a 7.1 KW air conditioner Fujitsu. Dispose of current air conditioner. Must be licensed. Must provide receipt for warranty of air con unit and labour.