Find trusted local electricians in Rozelle

• Repairing and replacing several existing lights that are not working properly. • Installing additional lights to improve the brightness and appearance of the property.

Require an Air Conditioning installer/labourer to assist in installations , no experiance needed, however needs to have experiance in confined space and roof work

I have 3 lights which need to be swapped out back to their original fittings. 2 are located on walls and are sconces and the third is on the ceiling which is an oyster light. The two sconces are like the bare light in the photos and the oyster to replace the other

We require a licensed electrician to connect a new electric hot water unit to the main electrical board at the front of the house. All materials supplied by owner prior to work commencing.(Except RCBO to be confirmed by electrician and owner can buy it from electrical whole supplier or leave that to electrician) Scope of Work: Connect Thermann Smart Electric Storage 125L hot water unit to main electrical board Install supplied RCBO and cable Hot water unit located in attic Electrical board located at front of house Run cable from attic to main board(access is available, walk in) Connect and test Might have other works that could quote separately onsite regarding the bathroom Unit Specifications Code Brand = Thermann Smart Electric Storage Capacity = 125L Normal heating = 3.6KW (15 amps) Max input = 4.8KW (20 amps) Voltage = 240V single phase Materials Supplied By Owner Cable: Code 4mm² TPS Twin & Earth 450/750V rated V-90 insulation RoHS compliant RCBO: Code Hager 20amp Single Pole C-curve 6000A breaking capacity 30mA RCD protection Site Information Location: Rozelle NSW All materials on site ✅ Tradie to advise if any additional materials required before commencing Requirements — Must Provide Before Accepting All of the following must be provided prior to booking: Current Public Liability Insurance certificate (minimum $5 million coverage) Valid NSW Electrical Contractor Licence number Certificate of Electrical Compliance to be issued upon job completion What Tradie Needs To Bring Electrical tools Cable clips/conduit if required Certification equipment for sign off

Light in our dining room is not working. It appears to be a connectivity issue. Would like an electrician to look at it and fix it.

Need to replace to broken exhaust fans. One in bathroom and one in laundry. Im 100m walking distance to Bunnings in Rozelle where new fans can be purchased and then installed.

Brigges & Stratton P2200 not used for 6mths need service as going around Aus .

We need help removing external store signage only. This task does NOT involve removing the lightbox or any electrical work. Task details: • Remove the front-facing sign panel/cover only • Sign is non-electrical • Access is straightforward from ground level / step ladder • Please bring basic tools if required (screwdriver / drill) Important notes: • No electrical work • No heavy lifting • Careful removal required (do not damage awning or structure) Experience preferred: • Handy person / signage removal experience helpful but not essential If you’re available tomorrow and comfortable with this type of task, please message asap!! Need task done tomorrow.

RCB06 on rear power circuit. Continues to Trips after 2–7 minutes. Outdoor GPO replaced but fault persists. Suspected moisture in cable or conduit. Just let me know your call out and hourly fee.

We have tried to isolate the issue of the RCD constantly switching to off but struggling to find the issue.

I bought new LED’s for my hallway lights and whilst the first one turns on the rest are failing and I just get a flick of light .. prob something to do with transformers but out of my depth now and need professional help! My quote is ex the cost of any transformers etc but you would need to provide these .. thanks

Licensed electrician to wire a new power supply to the circuit board located in the laundry. A new 20 amp circuit breaker is required in the existing vacant slot. Supply and install an isolator (not a switch) on the external wall as illustrated in the attached photographs.

I’m looking to see how much it would be to have a table lamp from North America (120v) rewired to Australia electrical specifications. I also have an Australian table lamp with “faulty wiring” that I might want fixed too.

Need new light fitting connected to existing wiring. Wiring is old (see images attached) without colour coded wires, so require licensed electrician to safely connect

Flickering downlight in kitchen, all others are ok but one flickers when circuit is on, keen for a fix or replace

I'm thinking 2x outdoor weatherproof garden too (4x plugs) installed on beam with cabling and conduct to protect it from current single outdoor PowerPoint (see photos of single position) or converting single to x2 doubles Front porch 2x doubles- 1 either side parallel to the PowerPoint inside each room either side on the front door. Photos attached. Please provide full Quote including supply of materials and labour to install & testing , including take away waste.

Two of my drawers have fallen off their tracks and the other won't close but I am unable to remove it from tracks to see if anything has fallen behind it - so three drawers need repair. I also have 3 x track lights in our basement that need replacing as the previous bulbs have gone. Please see photos attached for details.

Hi, My air con unit has stopped working. The circuit in the fuse box was on off, I flicked it back to on but still doesn't work

I need an electrician to replace about 8 light switches in an apartment They are currently yellow need to be white I will buy the plate just need them installed. I will meet you onsite Can I please get hourly quote thanks

From machine diagnostics, water heater is showing fault code 11 - gas, starter, or flame sensor. Heater will fire on when hot tap is opened, flame stays for 2-3 seconds then dies, restarts again, then dies. Suggests issue is with flame sensor. I need a heating/plumbing expert to confirm fault and clean/replace sensor.