Find an experienced plumber in Bundoora

There are 2 bathrooms/showers upstairs in a townhouse. One shower is slow to drain/has been backing up, and the other shower has also been affected. The toilet is currently running normally, but there was previously bubbling and slow drainage. Need someone experienced with blocked/slow shower drains to inspect and clear the blockage. Please bring suitable drain-clearing equipment.

The drain system is not working either need to replace it or fix it. Price is negotiable

Looking for a licensed plumber to replace my existing kitchen tap setup in Bundoora. Currently have a traditional 3-hole setup – hot tap, cold tap and centre spout. I’ve purchased a new Mondella Resonance pull-down kitchen mixer that I’d like installed. Job would involve: * Remove existing hot/cold taps and centre spout * Install new Mondella mixer, ideally through the existing centre hole * Connect new mixer to existing hot/cold water supply * Fit blanking caps to the two unused tap holes * Check everything for leaks and make sure mixer is operating properly * Existing AMF Cuno water filter under the sink – would like this retained where possible There is good access underneath the sink – photos attached. I already have the new mixer. Happy for you to supply any small additional fittings/blanking caps required and add them to the cost.

Hi, we have an existing mixer in the shower that falls off and we want to replace it. We have already purchased the replacement but need someone qualified and capable to install it. Please only respond if you have done this before and feel highly competent. Ideally would like this done before end of tomorrow/Wednesday, even better if you can come today. Please note there are three cats and a dog here so must be ok with pets.

Replace with new tap same one as in picture i have tap and hoses

I need an experienced plumber to install an Atlanta shower swivel outlet in an existing shower. I already have the new Atlanta swivel outlet. The female thread on the new fitting is approximately 1/2 inch (19 mm). However, the existing male threaded outlet coming from the wall appears slightly smaller (possibly around 18 mm), so I am unsure whether an adaptor or different fitting is required. The previous shower fitting was accidentally pulled away from the wall, so there is also a possibility that the existing male thread has been partly damaged. The job is therefore to: inspect the existing male threaded shower outlet and determine whether the thread is damaged; confirm whether the new Atlanta 1/2-inch swivel outlet is compatible; supply/install an appropriate adaptor or fitting if required; repair or rectify the existing thread if reasonably possible; install and correctly seal the new swivel outlet; and test the installation to ensure it is secure and watertight. I would prefer someone with plumbing experience who is comfortable dealing with damaged or mismatched threaded fittings rather than simply installing a standard shower head. Please bring appropriate plumbing tools, thread tape/sealant and any common adaptors/fittings that may be required. I am happy to pay separately for any additional parts required. Photos of the existing outlet and new Atlanta fitting can be provided/are attached. Please let me know in your offer whether you are a licensed plumber and whether your price includes the initial assessment and installation.

Kitchen sink and mixer tap install, and dishwasher connection

I turned gas off for a few days, couldn't turn back on the gas hot water system.

Hello, I would like to repair a kitchen mixer tap handle. The handle has come off from its base (hinge area), and it is no longer attached properly. The tap itself is working, but the handle is detached and needs to be reattached or fixed securely. I have attached photos to show the issue clearly. Could you please let me know: • If this can be repaired • What is needed to fix it (e.g. screw, pin, or replacement part) • The estimated cost Thank you very much.

Replace my existing Chromagen T20 gas continuous hot water unit to a Rinnai 32 gas continuous hot water unit with controller

I can turn the pilot light on, but as soon as you release it turns off

The toilet has been blocked, doesn't clear even after trying the plunger technique. Maybe a Toilet auger insertion with high-pressure jetting is required. A registered plumber who has a particular skill and expertise is required.

The toilet sliding door has become stuck it does close but wont open all the way. I suspect it has come off the rails and needs adjusting so it opens and closes properly.

I need a hot water system port installed in a new location. External wall of bathroom. Shower head on same wall. Pipes run through the roof. House is on the slab.

Toilet light switch gets stuck when switching on/off

The shower head is leaking; it could be a tap issue

I got a toilet leak coming out of side of toilet bowl. Please help fix

My toilet is running. The tank doesn’t fill and the flush is ineffectual. The water is running into the toilet.

Hot water washer potentially broken and tap won’t turn off in bathroom

Hello, I just need a handyman who can change the tap washers in the bathroom as the taps have a little water leak/drip when they are closed. The washers that need to be changed are for the sink, bathtub, and shower. This is for my grandma's house please affordable prices.