Find an experienced handyman in Inner West Sydney

Located in Ashfield. Current blinds are broken on 2 windows (main bedroom and living room balcony sliding doors). Would like them to repair or replace the blinds or replace with curtains. Supply and install either blinds (repair or replace) or curtains. Thank you

Need 2 x hook racks installed in our apartment. We have the racks as shown in photos. Plaster walls. Thank you

Purchased this guitar with unknown history. Had a friend look over it and said it is working but need a tidy up. Some things to note: - One of the tuning pegs is loose. - Neck is slightly bent. - Electronics working but need tidy up. - Apparently there is a battery which may need to be replaced, the back cover was not removed but there is a rattle sound from there. - Strings may need to be replaced. I imagine it would be best to agree on a price after an evaluation.

Looking for handyman to install a top-mount sliding door system onto a masonry wall, including installing the wooden backing board. Job includes: - Installing a 2m wooden backing board on top of door frame (see photo) - Mounting the sliding door track on the board - Drilling holes in the wall, backing board, and door as needed - the door is not pre-drilled. - Removing existing hinged door (see photo) - Providing or advising on correct anchor screws for masonry Must bring own tools, including drill and masonry drill bits The track is Roll track branded and video on installation can be found here: https://youtu.be/-WAjYG3YUt8?si=iGRzcL1rQg9z7-3I Please have experience with similar installs, own equipment. Ready to go asap!

There is an existing vent on the outside wall. I need to move that down so that it lines up with the inside kitchen cupboard and run the exhaust fan hose through the cabinet and through the wall to the outside. So it's about 4 bricks to be removed, punch a hole through the kitchen cabinet and inside wall, run the exhaust fan through and repair the outside wall above.

I'm partially renovating a bathroom which involves replacing shower screen, regrouting tiles and replacing the vanity. The existing shower screen will be removed before work is done and replaced after the work is done. Work involves: - Remove existing grout and Re grout tiles (wall and floor) in shower area - Remove and dispose of existing vanity (1.52M) - Install new bathroom wall mirror - Clean tiles, the marks from the existing shower screen and vanity will need to be removed - Install and plumb new vanity, basin, drainage and tap I will supply the new vanity (1.2M), tap, mirror and basin We are in a unit with parking underneath and lift access Budget quoted is a wild guess

Door hinge on integrated dishwasher over extended and now dishwasher door won’t close

Blinds cord in the home I am moving into is stuck holding the blinds in the Up position

Removal of 4 sheets of gyprock in the garage. Each sheet is approximately 1m X 2.8m. The gyprock has some mould.

Need fix replacing the kitchen sink’s knob/handle and loosening the other knob as well.

Uninstall and install new shaving cabinet. I will supply the new shaving cabinet but installer to provide the right screws.

Fix loose gate. The gate isn't fasten well anymore. Need someone to help come up with a solution, if that's concrete, bolting it to the brick below, or some other suggestion.

Following wet weather our door frame has warped substantially, sanding has not worked and it is getting worse. We’d like to understand the root cause and fix it.

Gyprock patching of the area in the photo. Dimensions approximately 130cm 55cm. This has to be done with the needed framing to support the gyprock.

Hey, I urgently need a handy man today - the shower door slipped out of its socket - not sure if it's because of loose screw or worn out seal.

Have a diverter valve and bidet seat attachment that needs to be installed in the bathroom.

Patch a hole in the wall and also repair small chip in vanity in bathroom

Repair Electrolux EDV6051 Update: added photo I got into the back and the belt wheel has melted and fallen off Motor still works, can rotate the drum manually by the drum doesn’t rotate when on. I assume it just requires a belt repair. Would love it repaired today as we use it A LOT.