Find a reliable appliance technician in Sydney

It is an under bench dishwasher in a meriton apartment. The dishwasher is breakdown and I have a new one to be installed. But i am not able to remove the existing one out. It looks like it get stuck in the joinery at some points. I can pull the dishwasher out by around 10mm and move it in and out by that distance but that is it. I can’t pull it out any further. I don’t know how this is being installed, it looks to me it is being fixed at some point behind it which I can’t access. I need someone one to pull the dishwasher out. That’s it. I’m getting rid of the machine, so if you need to knock it down, then knock it down.

Rangehood Installation with Cabinet Modification

1. I bought charcoal filters for my range hood. Need to unscrew the body to replace (not screw on) 2. Installing 2 vertical shelving system in a wardrobe - bought in Bunnings called flexi storage system.

Need to fix few fridges in the restaurant.

Fix a washing machine leak - it is coming from the bottom of the machine

The dryer hasn't been use much but it never heating. Turn on and off just fine.

Heat pump dryer is currently placed on unstable dryer stand, I need to have it moved from the stand to on top of a rubber mat on the washing machine. Flexible $.

I need an experienced handyman or plumber to connect my Bosch Series 6 Dishwasher today. ​The Problem: The dishwasher relies on a bulky Bosch AquaStop valve at the inlet end. Right now, the valve hits the wall-mounted power outlet next to the tap, so it cannot be screwed on directly. ​What Needs to Be Done: ​Supply and install a short flexible extension line (around 30cm) to drop or move the AquaStop valve away from the wall socket so it clears the outlet. ​Connect the dishwasher inlet and waste/drain lines, test for leaks, and push the unit into position. ​Required Hardware (Tasker to Provide/Supply): - ​1x 3/4" BSP (20mm) Male-to-Female Flexi Extension Hose (~30cm) OR a standard 3/4" Female-to-Female Flexi Hose combined with a 3/4" (20mm) Brass Hex Nipple. ​Note: Standard domestic dishwasher threads in Australia are 3/4" BSP (which measures approx. 26mm outer diameter on a tape measure). Please ensure you bring 3/4" fittings, NOT 1/2" mixer hose fittings. ​Timing: Looking to get this completed TODAY. Kitchen is currently clear and ready for install.

Our Dishwasher was showing F30 warning and is now not coming on. It’s a Fisher&Paykel about 2yrs old.

Connect the water pipes properly to the washing machine, it was not installed properly so water leaks

My new fridge won't fit into the kitchen opening because the door frame is blocking it. It only needs an extra 2 cm of clearance. I'm looking for someone who can temporarily remove the door frame, help fit the fridge into the kitchen, and then reinstall the frame afterwards. At the same time, I also need someone who can reverse the door opening on an OLG fridge.

Dishwasher - deliver & installation Pickup location: Camperdown NSW 2050, Australia (NOT University of Sydney - not sure why address auto-corrects.) Drop-off location: Eastwood NSW 2122, Australia Removals size: A dishwasher Stairs: No Tools for installation: We don't have tools. There are pre-existing utility lines for dishwasher installation.

Have a new kitchen- need the sink, tap and dishwasher connected to pipes and drains etc.

Need new washing machine installed. Need someone with a large strong wench to unscrew old inlet pump which is tightened under sink.

This washing machine overfills during the wash cycle have cleaned filter set water to low put tiny amount of clothes - still over fills please fix asap

Gasket spring on door got loose, tried reinstalling. Still leaks water. Needs a professional

Old dishwasher has already been removed. I just need the new dishwasher slid into place, connected to the existing water, drain and power, levelled, and tested for leaks. Existing plumbing and electrical are already in place. Looking for someone experienced with dishwasher installations.

The clothes dryer starts cycle and stops randomly after a few minutes then I have to press the door at the bottom and it starts but after few minutes it stops again so i need to keep pressing the door and hit start button again and again to keep the cycle going.

We’ve just had a new Bosch Washing machine and dryer delivered. The washing machine seems to be setup fine but the delivery guy couldn’t connect the drainage on the dryer as he said it wouldn’t fit in the hole. Previously we had both washer and dryer plumbed in, so wanting someone to come over and check dryer, potentially make the hole in the top of the drain a bit bigger so the dryer pipe can fit in, and just generally check both are connected properly and pushed back as far as possible. Thank you!

I’ve had my washing machine delivered but it hasn’t been taken out of the box or installed I need a plumber/tradie to do this for me, i’m not sure if it will require 2 people as it’s an 8kg machine