Find a reliable appliance technician near you

my washing machine is not taking water out

Miele dishwasher not draining

Gas and smoke alarm compliance check pre rental. Would also like the the outdoor central gas unit looked at as it’s blowing cold air.

Rangehood servicing cleaning filters, inspecting the motor and fan Brand : smeg

Fridge leaking from underneath.

My dishwasher is not draining despite emptying the filter rack .

Wanted to replace my old gas cook top free standing oven with new one , I do have new one , only needs tradie to replace with all safety measures and provide me cc

Beeps intermitedly, with red light flashing when power switch is turned-on.

F11 on Asko dishwasher won’t drain. Stops and then keep beeping St Kilda east ASAP

My Euro washing machine door latch won’t open. Need a technician to unlock it. E02 error on display

The tap under the laundry sink that attaches my washing machine is leaking large amounts of water when I do a load of washing. The attachment from the washing machine feels tight so I am assuming the problem is the tap.

The hot water pipe does not screw on properly onto the tap (have tried in more than one property in the past). When attached, it leaks and sprays water

I would like to change my no longer working gas oven to an electric oven, installer who is electrician said a plumber needs to disconnect the old oven.

Its sounds like it trying to pump water in, but just takes a bit and stops, and all over again But definitely drains and take some water The bottom of the dishwasher is clean, drain pipes are clean and correctly installed After one hour of pumping and draining the water it stops and only Inlet/Drain flashing miele g4101 dishwasher

Water outlet hose needing to be replaced as soon as possible.

Washing machine flooding with water, had to turn running water off. I suspect the valve inside might be faulty, even while off the water was flooding the machine having to constantly drain it.

show me how to use a jumbuck gas 2 burner gas bbq

I have bought a manual labelling machine called the ‘Benchmate’ it comes with a manual and QR codes with links to YouTube videos on how to set it up, just need some who is savvy.

Need to connect my washing machine, current pipe is too short and isn’t reaching the water pipe!

I have a new Beko BRH70UX 70 cm undermount rangehood ready to install. Looking for an experienced rangehood installer/cabinetmaker to remove the existing rangehood and install the new unit. Scope of work: * Remove existing rangehood and dispose of old unit. * Install new Beko BRH70UX 70 cm undermount rangehood. * Existing kitchen has a gas cooktop, so installation needs to comply with applicable Australian clearance requirements and Beko installation requirements. * Existing cabinetry/shelf will likely need to be modified/raised to position the new rangehood correctly. * New Beko requires 150 mm duct connection (120 mm adapter also supplied). * Existing ducting is only 100 mm, so this needs to be replaced. * Ducting needs to be rerouted to the other side of the cabinet/duct path. * Please supply/install appropriate 150 mm ducting, joins, elbows, clamps and external connection as required. * Keep duct run as short/straight as reasonably possible. * Modify cabinetry neatly and securely around the new rangehood. * Connect to existing power point * Test rangehood/extraction after installation. * Clean up and remove rubbish. Rangehood: Beko BRH70UX Width: 700 mm Depth: 296 mm Height: 254 mm Cabinet cut-out: 665 × 265 mm Duct: 150 mm preferred Photos of the existing installation and new rangehood are attached. Please quote for labour + materials and clearly identify any additional costs. Looking for someone experienced with rangehood installation, ducting and kitchen cabinetry, rather than a basic appliance installer. Budget: $700–900 depending on the amount of cabinetry and ducting work required.