Find local electrical rewiring electricians near you

Rear indicator lights/brake lights wiring severed and need reconnection. Wiring located under rear fender. New number plate bolt styled LED lights need to be installed. New LED Number plate bolt lights are supplied. Bike is undercover with lighting.

Main wire to the connection hookup on trailer needs replacement (which I have already). One wire has broken so trailer left light no longer working. Need to re register it asap. It's a simple job but I'm not a competent electrician! It has to pass rego.

We bought a new oven but the plug is too 'fat' so the oven won't slide right back to the wall. I have bought a clipsal side entry plug to be used to rewire, that should be flat enough. Should be a super quick job.

Garage has an old electrical box and wiring. Need to re-wire and upgrade the electrical board.

Remove old wire and replace with new wire supplied and connect existing trailer lights for a 8x 5 Box Trailer

Caravan has some non working lights and their is exposed wiring. Not sure how much need to be replaced, but i am also willing to go for less fixtures.

Need someone to rewire a light tonight or tomorrow. It’s 1 ceiling light wire.

I need 2 JetSki trailers re-wired towards the ends as my dog has chewed the wiring

2 lamps currently wired as hanging lamps (already disconnected), want to change the wires to switch cords (already bought). Will require cutting the new cord.

I need this installed today and completed before 230pm. I have a Chinese ZX Auto ute that has a busted tail light. I have 3rd party LED tail lights that I need mounted and most importantly, rewired onto the existing wiring. See photos.

My outside down light has gone out and needs replacing however it needs to be rewired and replaced. Need to be licensed

I need a new light shade that I’ve purchased to please be attached to the ceiling - photos attached.

Have a table lamp needing rewiring located point cook

Replace lighting unit, ballast gone bust, new lighting unit need to be supplied, and rewiring of towel rail switch.

Seeking an experienced electrician or electronics engineer to replace a hardwired IEC power cable in an benchtop lab appliance to use an Australian IEC cable. The appliance is a laboratory heating bath. It has a hardwired IEC cable with a UK fused 2A plug. As the appliance will be used regularly in Australia, I would like the appliance to instead use an Australian grounded IEC cable. Because the cable is hardwired, the appliance will need to be taken apart and the new cable rewried according to AS/NZS electrical safety standards. The appliance is out of warranty but is in good working condition. The appliance is rated for 240-250 VAC, 50/60 Hz and was manufactured by Nickel Electro Ltd (Clifton brand).

the lamp cord has snapped and i need a new cord rewired so i can use it

A light fixture has fallen and the cables are broken. Need it rewired and working again.

I am requiring a repair of an outdoor lamp. The lamp currently has cut wires and can be disassembled into two pieces, allowing the reworking and connection to be concealed. As this lamp will be placed on a balcony, it is crucial that the wiring and plug be waterproof to ensure safety and durability in outdoor conditions. Ideally, I would like this repair to be completed today if possible.

A vintage table lamp needs a fairly simple rewiring, to replace its old, broken wiring.

I need help to install the following: - two outdoor wall lights - two outdoor security lights on alfresco eaves - three pendant lights in the kitchen - three internal wall lights All of the lights have been pre-wired in a newly built home.