Hire trusted experts for dishwasher repairs in Central London

Hi, I'd like a quote for two small jobs at a flat in E2 9DP, done in one visit. Parts are already on site. 1. Indesit DSIE 2B10 UK N integrated 45cm dishwasher: both front adjustable feet are bent and the machine leans, so the door won't close. Slide it out, fit the new feet, level it and set it to worktop height, check the door closes and lines up, fix the top brackets to the worktop, refit the plinth and run a test cycle. Please check the threaded sockets in the base aren't damaged. 2. Shower: replace the broken clip on the wall-mounted handset holder, reusing the existing holes if possible.

The dishwasher won't drain.

Hisense dishwasher, showing Error F54

I need an experienced kitchen fitter/handyperson to fit a cabinet door panel to my integrated dishwasher. I have the door panel, the dishwasher fitting template/brackets and screws, plus a handle to match the neighbouring cupboards. I’d like the panel aligned neatly so it sits flush with the adjacent cupboard doors, with even gaps, and for the handle to be fitted if possible. Please bring appropriate tools and experience fitting integrated appliance doors. Photos attached.

I want to install a full-size integrated dishwasher in an existing kitchen cabinet next to the sink. Existing cabinet is approximately 598mm wide. Worktop height is approximately 890mm. There is currently no dishwasher here, so I need someone experienced to: inspect the existing cabinet/plumbing/electrics remove/modify the cabinet as necessary advise what dishwasher will fit create/connect water supply and waste if required install the integrated dishwasher ideally reuse/fit the existing grey cabinet door to the dishwasher I have not purchased the dishwasher yet because I'd like someone to confirm what will work first. Photos attached.

An integrated dishwasher has come unsecured from the wooden worktop. I need someone who can bring materials to resecure the dishwasher properly

Our commercial dishwasher has developed a leak. I suspect it may be related to limescale buildup around the computer/control panel area, but I need an experienced technician to properly diagnose and resolve the issue. I need someone experienced with commercial kitchen equipment to come and Inspect the unit to locate and fix the source of the leak. Perform a general maintenance check and service, as the machine has not been serviced in a while.

baumatic dishwasher isn't working

The wooden door attached to the dishwasher has come off see attached photos and needs re-installing.

I need an over the counter dishwasher connected to the pipes under the sink. The cold water is currently connected to the washing machine so I need it disconnected and a Y piece connector added to split the cold water. I have all the material Washing machine hose is too tight for me to get off with the water pump pliers (Ideally asap or the council can do it on Tuesday)

Bosch Dishwasher Lost Heat Error E:09 - Most common causes (in order of likelihood) Failed heating element inside the circulation pump / heat-pump assembly (by far the most common). Corroded or damaged wiring/connectors at the heater terminals. Faulty heater relay on the control board (less common).

Task Description: I have an integrated IKEA HJÄLPSAM dishwasher (Ikea HJÄLPSAM (HJÄLPSAM 902.224.26) that has stopped working completely. Issue: Dishwasher appears completely dead No lights on the control panel No response when pressing the power button Integrated model behind a cabinet door Previously working normally What I need: Diagnosis of the fault Repair if possible during the same visit Please include any call-out/diagnostic fee in your quote Let me know if any replacement parts would be extra Possible faults (for reference): Could be a power supply issue, wiring fault, mains filter, door switch/interlock, or control board fault. A full diagnosis is required.

Change dishwasher because the old one was showing the same sign and after a while the new dishwasher stops working and shows the same red tap

Choose the mode of washing ( eco) and then close the Zanussi dishwasher door, this time I didn’t hear a click and the dishwasher didn’t start washing with water coming down as usual. Instead The door didn’t lock , I can still open it, and nothing no water coming down, nothing happened at all.

Replace an existing fully integrated Bosch dishwasher with a new Miele 7085 (tall XXL height model). https://www.miele.co.uk/product/12865050/fully-integrated-dishwasher-xxl-g-7085-scvi-xxl-autodos-stainless-steel The job: 1. Remove the old machine (I'll dispose of it myself) 2. Fit and plumb in the new one, water, waste and power all in place 3. Carefully refit the existing kitchen cabinet door The new machine has been measured to fit and the plinth clearance is already cut, so should be a straightforward like-for-like swap with everything ready to go.

1. Integrated dishwasher Convert an existing 60cm base cupboard into space for a full-size fully integrated dishwasher. The space is 60cm wide, approx. 85.5cm floor to underside of worktop and approx. 63cm worktop depth. Work required: * Remove existing cupboard carcass/shelves while keeping worktop in place * Prepare space and install/connect integrated dishwasher * Connect required water supply and waste * Reuse existing grey cupboard door as dishwasher front if compatible * Retain/refit existing grey plinth so it remains continuous * Make any necessary door/plinth adjustments and test dishwasher I haven’t purchased the dishwasher yet and would like the fitter to confirm compatibility before I order. 2. Pull-out bin Remove the existing three-compartment pull-out bin, frame and runners from another cupboard and replace with one larger single pull-out bin. Cabinet interior is approx. 27cm W × 52cm D × 70cm H. I’d like to keep the existing cupboard door/hinges and maximise bin capacity. I can purchase the new bin once the fitter confirms which system will fit. Photos available. Please quote for completing both jobs, including the cabinetry and plumbing required. Experience fitting integrated dishwashers and modifying kitchen cabinetry is essential.

We have had an IKEA dishwasher installed but we need to add the finishing touches to the job. The dishwasher is already plumbed in. The door panel is loose and we need to secure the left hand side of the dishwasher to a side panel to stop any movement.

I purchased a dishwasher (brand new - ElectricQ) and it hasn't worked properly since installation. It's going to cost me £150 to get someone to come out so I'd rather give someone local some money to support me.

Dishwasher is not draining propoerly, and control panel is glitchy. Sometimes it lets you choose a setting and runs normally, but most of the time it rejects and glitches when you choose a mode, and so it’s hard to get started