Find experienced local tradies in Baulkham Hills & Hawkesbury

Remove folding arm awning , measures 7.8m by 4m motorised. Currently Fixed into brick wall.

We have removed a wall and doors. This task is for the following - Supply & Install any ceiling framework required to repair ceiling - Supply & Install gyprock to ceiling framework - Supply & Install 90mm cove cornice where required - Gyprocker to set and sand all areas as required (includes basecoat, topcoat and sanding) - Remove existing half/cut tiles from near existing wall - Supply & Install skirting, to best match existing, where required - Remove trade waste & tidy site

The aquacheck plasterboard is sagging from the corner. Need to get it fixed.

These steps need to be built in preparation for tiling.

We need acrylic rendering completed for an unfinished job for a new home - a couple walls and a couple of rooms

Finish sauna install. Front glass section has 4/6 locks in. Left hand side is in. Bottom on right hand side is in, top two remain out. Glass heaters to be installed. Door handle to be tightened. Roof cover and oxygenator to be installed. For an experienced installer it’s a 30min job. Will need two people.

Hi I have a Revel traditional sauna that I need to be hard wired by a licensed electrician and possibly run back to the main switchboard and connected by it’s own whole new circuit potentially. I’ve been told it needs 4mm wire. The switchboard is approximately 15 meters away from the sauna. Any questions pleas ask

Build flat packed custom built wardrobe and install in wardrobe. Wardrobe is a walk in robe. Easy to assemble with pieces numbered. Combination of wardrobe, drawers and shelves etc. handles for drawers and wardrobe doors will need to be fitted. All hardware etc supplied. The wardrobe cupboards consist of one tall corner hanging cupboard, two sets of drawers and two small corner shelving units to connect them and a top that runs along drawers and corner shelves. Please note easy to assemble custom built and numbered. Completed cupboards will be delivered on 26 November, would prefer installation to happen either Friday 28 November, Saturday 29 November or Sunday 30 November.

I've to get 2 walls and 1 pillar rendered before painting them. Walls are of approx 2.4x2.3, 2.3 x 2.4 and pillar 2.3x0.3.

After some repairs on the roof some power points around the kitchen stopped working, when I put the respective breaker up its goes down again.

Quick job to put up new ceiling and cornices in bathroom. See image 3500 x 1900 We will remove existing gyprock and insulation down and have it ready. I will provide: Gyprock Cornice New exhaust fan New insulation batts 1kg of Gyprock acrylic stud adhesive (see images) 2.25kg of topping compund (see images) 1 roll fibreglass joint tape (see images) Just come with your magic tools and experience to get the job done fast! MUST BE RELIABLE!!!

Install awning for door.

Patch a hole in drywall please supply all materials needed.

Looking to get renderings for a fence wall. Estimated area 33SQM. Looking for acrylic render or texture rendering

There is a hole in a gyprock wall which needs to be fixed. After fixing, it needs to be painted with the same wall colour tone.

Install 4 power points(All have wires nearby Install 1 oyster light (Old one has been taken out already, just need to install new Change 1 light switch

Repair render in spots around the house. Rendered smooth I will paint the render myself when it has been repaired

Re gyprock and paint

Gyprock and cornice laundry ceiling Gyprock around new door installed Cornice failed patio area as shown in picture

Purchase the Copenhagen 2 seater Sauna and it's quite difficult to put together, as I have a back problem. Usermanual below. Takes 30 minute apparently to put together. https://support.alpinespas.co.nz/support/solutions/articles/27000082006-copenhagen-sauna-installation-manual-2025 May also need assistance to throw garbage away (all the boxes) optional. Quote is negotiable. Thanks