Find experienced local tradies in Baulkham Hills & Hawkesbury

Install Felt wall or build Gyprock wall for reception area

Repaint the same colour of the render and mailbox. Contractor needs to supply paint.

Re-tile an upstairs veranda at Glenhaven. The old tiles and mortar bed are already removed back to the concrete slab — it's ready for you to start. The veranda is fully under roof so it gets very little water, but it sits above a lined ceiling, so I want it membraned properly while the slab is open. Area: approx 23.6 m² — a main section 6.85 m × 3.0 m plus a return 3.76 m × 0.82 m. There is no floor waste; the deck falls off the open edge. Scope of work: Patch and repair spalled concrete around the slab edges, prepare and prime the substrate. Sand/cement screed to falls — minimum 1:100 to the open edge, no ponding. Keep total build-up to approx 20 to 40mm. Waterproof to AS 4654.2: bond breaker at all junctions, membrane over the full deck, upturns 100 mm above the finished tile level at all walls, membrane dressed into the 2 x door reveals, and a reinforced membrane collar and sealant fillet at each balustrade post — the posts are fixed through the slab. Clean down and take all rubbish away. I supply: tiles and grout. You supply and price: membrane system, primer, bond breaker, screed materials, adhesive, levelling clips, silicone. Please include in your offer: Your NSW Fair Trading licence number covering waterproofing and wall & floor tiling Current public liability insurance Photos of a previous balcony or deck you've waterproofed and tiled Your written warranty on the waterproofing Price broken into waterproofing / screed / tiling

I have a rhino 180 awning needing to be install on a rhino flat platform roof rack

Paint rendered retaining walls. Approx 40 lineal metres averaging half a metre high

Hi, I’m looking for a licensed electrician to supply and install 1 x 15A power point in my garage for EV charging. The proposed location is marked in the attached photo. The switchboard is immediately outside the same brick wall, very close to the proposed socket location, so the cable run should be relatively short. Requirements: * Licensed electrician only * Supply and install 1 x 15A GPO * Dedicated circuit with appropriate protection * Supply all materials and cabling Location: Baulkham Hills NSW 2153 Photos of the garage, proposed socket location and switchboard are attached.

Hang up a 65" TV bracket on to a gyprock wall. Hide the cabling in the gyprock wall. Hang up the TV.

Instal an awning on backyard, need to install 2 mounts on the wall first then put the 3 meters awning on. At least 2 ppl required with ladders

Need a sauna assembled from the parts after a home move - it is very straightforward and clips together, very similar to this: https://www.luxoliving.com.au/products/harlow-2-person-carbon-fibre-infrared-personal-indoor-sauna?_pos=1&_fid=a11be9fc2&_ss=c All sides are very lightweight except the front door panel which is heavier because of the glass which I can help you put in place - all sides clip together so very little screwdriver work involved. Not more than an hour or so of work.

Looking for a local electrician to replace a ceiling light as below photo. The handyman said something may have burnt out inside so electrical work may be required. Also, seeking help to replace the 4 power points as bleow photo. Please let us know your availability. materials and labor cost with the quote. Thanks.

Patch few opened Gyprock areas to fix some plumbing issue

I have a wardrobe that needs new framework to be built and installed into it. Measurements of the cavity are 240cm height x 130cm width x 52 cm depth. I want to make it more functional and a better use of space. Would need a hanging rack, a few shelves and drawers. I’m open to different configurations. Pic 1 shows the outside of the wardrobe and the inside is currently a single hanging rack and a single shelf, see pic 2. Please note there could be 2 more wardrobes if I’m happy with the work. Thank you

Need three power points to hang the tvs. Ones is downstairs. The other two upstairs with easy access to the roof.

Stair balustrade to be painted (light sand, primer, gloss white x 2 coates). Perspex will be removed

I need to get some gyprock work done around my house. Work includes: 1. Patching all electricians cutouts (around 25) 2. Patching all carpenters cutouts (2 total) 3. Fixing one corner of a wall (photo attached) 4. Fixing existing gyprock on two walls. (Photos attached) All quotes must include sanding as well, no painting required as I will repaint the entire house.

Bedroom TV Wall * Install a recessed TV wall box (supplied by me or included in quote) suitable for: * Double power outlet * TV antenna point * Data/CAT6 point * Position box at TV mounting height. * Relocate/extend existing cables if required. * Leave ready for future wall-mounted TV installation with hidden cables.

I need a plasterer on Monday to assist me with plasterboard & cornice installation , external trim angles & setting etc. All materials provided. Please offer your hourly rate / day rate. Potential for on going work. Cheers

I have a new awning not attached to the van that has a bent pole. I have an old awning with a straight pole. I need the poles switched and the awning fitted on the caravan

Gyprock done on both side of the wall please the photos and some patch work as well

Install 2 solar lights & 1 solar camera on brick/render wall must have tools and experience Tidy work is appreciated