Find an experienced handyman in Dulwich Hill

Installation of blinds, will require drilling of curtain rod. Removal of curtain rods: all curtains have been removed. There are 5 rods.

Install 3 x ceiling fans with lights, where existing lights are. Ground floor flat. Concrete ceiling. Electrician with licence and insurance preferred. Thanks

I am looking for an experienced carpenter who can fit a frame and door under my stairs. Expecting cost of materials will be applied on top of my price

Render a section of wall - about 2.5metres x 30cm. Need to render around a PowerPoint and an nbn point

Lost the remote to our ceiling fan. Need the new remote and receiver installed.

Tidy up peeling paint on inside and outside of bathtub. See photos

1. Repair flyscreen falling out of frame 2. make 2 doors close more smoothly 3. Glue label back onto shower tap

Install pre-purchased frameless shower glass panel after tiling. Tiling and grouting will be completed prior to install. Fixed panel (no door). Apartment bathroom. Experience with frameless shower screens required. Needs to be siliconed same day or can return next day Photo is of existing bathroom- existing bath and screen will be taken down. New waterproofing and tiling will be done to convert the shower the day prior (weds 11th) Have included photo of purchased shower screen that will provided onsite. Any other tools needed to be supplied

Hi, I need a DC ceiling fan (Eglo, Seacliff 52") installed in my unit in Dulwich hill. It's and older unit, so it's a concrete ceiling. There is an existing light fitting and a switch on the wall 2 metres away from the light fitting.

One chain broken, need to fix

The drain under the kitchen sink is blocked. Tried unscrewing the s-trap to take some things about but this is just building up with water causing a leak. This is for a unit.

Install 3 x blinds. 2 x Click2Fit Roman Blinds: TUTORIAL HERE: https://m.youtube.com/watch?v=w_XWfA797_M 1 x Blockout Roman Blind GUIDE HERE: https://www.blindsonline.com.au/content/instructions/bo-roman-deluxe-guide.pdf?srsltid=AfmBOorpGQcxD8f-mJd8cZ4qLxhly1HFDxdW7rR_Fyub-nXw23p47cbH Will require all tools/drill and relevant experience.

I need an old stained glass window soundproofed in the front bedroom of my house. I am a renter so cannot do any major reconstructions on it. The bedroom is on a busy street and picks up a lot of noise from traffic.

We have a 900mm (wide) shaving cabinet that needs to be installed on a fully tiled bathroom wall (above an existing vanity/sink). It is replacing an old mirror which will also need to be removed please.

Looking for someone who can install frameless shower glass. Will need to drill holes in tiles. Tiles have been installed onto fibre cement board there is roughly a 15mm cavity between cement board and brick wall for plumbing. Will need to silicone to prevent water escaping past the shower glass. Will need to slightly trim bottom of bracket to clearance shower step. The bracket that attaches to glass is full length. Shower screen was purchased from future glass. Will need to check before drilling holes but there should be no plumbing or electrical in the way but better safe than sorry.

I’ve got a few odd jobs around the house to get done: - install a small shelf on the wall - grout some gaps in the bathroom - hang up a picture (brick wall) - paint ceiling where there was a leak. (Prepare, sand and paint) approx 2m2 I will supply all materials and paint.

Need a handyman to help me put my shelf up🙏🏻 I have the materials (2 pine shelves, 6 brackets, screws and plugs) but not the tools or skills 🥲 Would need help making it level and drilling into my brick wall. I would love if someone could come today🙏🏻

Looking for an experienced electrician or capable tasker to install 3 Ventair DC3 ceiling fans in my apartment. Fan model: https://ventair.com.au/product/dc31203wh-l Details: - Bedrooms under 20 m² - Ceiling height ~3 m — no extension rod purchased (please advise if optional rod recommended) - Fans replace existing lights (existing wiring points in place) - Fans supplied by me — remote control + LED included What I need: - Remove old light fittings - Mount fans safely (fan-rated bracket if needed) - Wire & pair remote controls - Test fan balance & operation - Test LED lights: on/off, dimming, tri-colour settings - Certificate of Compliance (CCEW) if licensed Requirements: - Experienced with ceiling fan installs, preferably remote-controlled - Bring own tools - Itemised labour quote only Please confirm licence / experience and estimated hours. Thanks!

Rebalance ceiling fan and try to stop slight clicking sound. If not able to stop clicking, looking 2 swap the fan in my master with fan in spare bedroom