Find trusted local electricians in Darlinghurst

Hi! We’re after a licensed electrician for some light work at our place in Potts Point (near the Coca-Cola sign and Kings Cross Station). We’d like a couple of double power points installed in the living area and bedroom, and a quick check of the existing ones to make sure everything’s working safely and properly. Nothing too major – just want it done by someone professional.

Qualified electrician to Replace induction cook top

Electrical rough-in required, must be done on Friday 4th July as gyprocking will commence on 5th of July. Scope of works as follows: Remove: 4 x surface mounted ceiling lights 1 x exit light (but retain power feed) 1 x gpo on ceiling near front window 1 x ceiling mounted switch near front door Extend existing wiring to accommodate: 2 x wall lights (“WL”) 3 x pin down lights (“DL”) 1 x pendant light (“PL”) Note: Downlights where ceiling has been removed had plug-in base/socket.

Ethernet cable not working well in bedroom . Main cable was loose in lounge but works perfectly

I have tried but can't do it.Water meter replaced and pilot light went out. Now only cold water. I checked the new meter and it is in the "on" position.

I have a glass roof that is controlled by an electric motor and linked to a flexible speed drive (TECO FM50). The roof is getting stuck and I need an electrician to determine whether the motor needs replacing and then do the work.

Replace 2 downlights in existing ceiling (hardwired?) (we have the replacements) 3 powerpoints small rangehood above stove not working, inspect power.

I have three hard wired smoke alarms that are over 7 years old and need replacement.

Pendant light needs installing In living room above dining table in small apartment

Need to install an IKEA light fitting on the ceiling. You will need to provide your own ladder and be a qualified electrician. Should only take a few minutes. I'd do it myself if it wasn't illegal!

Need a new power point installed from an existing hardwired oven outlet in the Kitchen. The existing hardwired outlet is in the wall and we just need to connected/converted into a power point. The wall is plastered so no new wiring/wall modifications are required

I need a licensed electrician to install a pendant light in an old house (proof of license required). Would like it installed asap. Pictures below.

Wires have become disconnected in the cord of a lamp just before the plug. So I think I just need the plug cut off and the wires reconnected then put the plug back on. But hey, I’m not an electrician! It looks like a pretty simple repair tho

Old underbench oven aready lifted out, its wiring has to be clipped and added to a power point as I have another underbench wotha actually a plug I need to slip in. I have the new power point for this. Also I have another yellowed powerpoint over kitchen bench to be replaced with a white fresher one. Then a single power point in cupboard for DW, to be replaced with a double one I have. Basically the job is 3 power point installation and I have the materials and estimate no more than a 30 mins to 45 mins job.

Task 1) Wiring & Testing: ●Wire parallel connection for 33 letters of LED sign letters and connect to controller. ●Extend and run wiring down to fit off a switch for operational control. ●Test the cool room light to verify proper function.Identify and fix any electrical issues if present. Task 2) Dedicated Circuits for Ice Cream Machines: ●Run three dedicated circuits to support the shop’s ice cream machines: - One (1) 16A circuit for a single ice cream machine. - Two (2) 20A circuits for additional for two ice cream machines. (Currently there is only 15A and 10A socket installed) Task4) Test existing shop sign -open up and test if shop sign if it is getting power or not and rectify if it isnt TEST AND COMMISSION ALL INSTALLED

Investigate fault in light circuit

Replace the cord on this pendant light. Want the cord to be woven through the chain. Have the new cord in hand, picture provided.

Having an electrical issue in my living room. 5 Downlights stopped working, they're on a dimmer. Let me know if you've any question, need a Sparky to check what's going on and fix it. Available all day every day Ps: appartment is in an old building. Thanks

Electrician to terminate a wall light, remove light.

4 lightbulids inbuilt into the roof and wall will require screwdriver, will pay for the lightbulbs separately