Find experienced local tradies in Baulkham Hills & Hawkesbury

Few holes in gyprock walls to be repaired . One large hole and few small ones

8.00 am start to assist with gyprock installation to a ceiling

We have various projects around Sydney that are in post construction defect phase. We require patching and painting service on an ongoing basis.

I need a PowerPoint installed in the room (‘marked in green) where there is already a PowerPoint at a different location (marked in red). There is also a switch board behind this green marked wall. So 2 options to get the wire for power point on the green marked wall.

about 2 meters from existing power point

Install water proof power points for smart toilets

Need to render the side of my alfresco. After the screeding and tiling was done - We need to render the side of the tiling to be flat and painted over. The length of the patch is about 7.5m and the thickness of it - is about 7-12cm

Looking for extra labour with experience with Micro cement or Suedofino interior rendering. A project that requires a bit of Flexibility on timings. Payment negotiable -with options of hourly or set price to be agreed in advance

I have a new awning not attached to the van that has a bent pole. I have an old awning with a straight pole. I need the poles switched and the awning fitted on the caravan

Gyprock done on both side of the wall please the photos and some patch work as well

Install 2 solar lights & 1 solar camera on brick/render wall must have tools and experience Tidy work is appreciated

What needs to be done: I have 3 plasterboard/drywall holes in my study nook that need to be properly patched and made good. The holes are a mix of sizes (two small to one large hole). This is a completion job — a previous tradie left the work unfinished. Patch only required — no painting needed. Scope of work: ∙ Inspect all 3 holes ∙ Patch and fill using appropriate method for each hole size (mesh patch, backing board, or filler as needed) ∙ Sand flush and smooth to a clean finish ready for painting at a later date ∙ Clean up on completion

Looking for an electrician or experienced handyman to replace a few cracked wall plates in my home. Work required: • Replace 1 x light switch wall plate • Replace 2 x double power point wall plates • Ensure all switches/outlets are secured properly and sit flush against the wall • Check everything is working correctly after installation The existing plates are cracked, so they just need swapping for new ones. Wiring should remain the same. Photos attached showing the current setup. I'm happy for you to supply the replacement plates (standard white) or I can reimburse for materials. Flexible with timing but would like it done sometime this week or next. Prefer someone with electrical experience (licensed electrician ideal) since power points are involved. Should be a quick job (likely 30–60 minutes).

Cut out in the wall needs to be fixed

I need a power point moved up the wall to hide it behind the tv.

I’m looking for a licensed and insured gyprocker to carry out ceiling patching, sanding and sagging repair work in my home. The ceiling was a glue only job, so if current gyprock can be screwed to the ceiling battens. Most rooms are currently empty with minimal furniture, so it should make access and clean-up slightly easier :) Rooms Overview Kitchen (The room mostly affected by sagging): Remove and replace approximately 6 square meters of gyprock ceiling. Open to suggestions here…. Living Room: 2x old oyster light holes & 1x speaker hole Dining Room: 1x AC vent, 1x oyster light hole, 1x speaker hole Garage: 2 x AC vent holes, 1x old speaker hole, 1x downlight hole and 6x old screw holes. Laundry: 1x oyster light hole & old fan hole Bedrooms (x4): 1x oyster light hole each room) Hallway: Patch light hole Prop and screw: Garage, 4x bedrooms Requirements - Must be licensed and insured - Quote must include all labour and materials - Clean, professional finish required All areas need to be finished and ready for me to paint. Quote to include all labour and materials.

Installing awning in backyard. 4*3M

accidentally drilled a screw into a power cable inside a stud wall, which initially caused the circuit to trip. I have already cut open the drywall to locate the issue, so the damaged wire is fully exposed and ready for fix (see photos). power is currently back on after removing the screw, but we switched off now to fix the wire insulation. We need electrician to repair the damaged section (likely with a junction box ) and safety test the circuit. Thanks

Small gyprock patching. Ready for painting

I need 5 extra power points installed, one fixed (looks like a blown fuse) and fix a ceiling light. I in a single storey house with both ceiling and under house access.