Find an experienced handyman in Canberra

Hi, I am looking for quotes to install 2 x fixed skylights.

Towel hook needs to be repaired, see images below.

Frames to 2x IKEA cabinets have already been built - just want someone to assemble/install shoe racks, pull out baskets and shelves, put doors in and install handles. Need someone to move washing machine and dryer into position in a new laundry and help plug them in (holes that have been cut in joinery might need to be made a bit bigger), and finally, screw small ikea garbage bin into side of a vanity.

Small hole in gyprock in lounge room

Here is the link to the bull bar. Installation instructions are on the website. https://offroadanimal.com.au/predator-bull-bar-to-suit-toyota-prado-250-series-2025-to-current/

My sliding door fly screen needs to be replaced. The mesh is black

I have four blinds that need to be hung and the other blinds to be removed.

Job Description – Garage Door Repair Needed My automatic garage door opens correctly but will not close properly. When pressing the close button on the remote, the door starts rolling down but then quickly reverses back up after moving a short distance. From inspection, it looks like the issue is coming from the bottom corner roller area, which may be sticking or misaligned. The corner panel also appears slightly misshaped, likely causing the door to bind. Please see the attached photo for reference. Work required: Inspect the corner roller and alignment. Adjust or replace the roller if necessary. Check and realign the corner panel. Ensure smooth and safe operation of the door after repair.

Need someone to reattach door to tracks.

Our garage door has a dent & scratch on it. When reversing a car, the bull bar dragged on the door. The dent & scratch is approx 1 meter long & 20cm high. We are hoping someone can push out the dent and repaint the scratch.

I need insulation installed under the house floor. The house is raised, there is a door that you can enter from, there light that comes through some vents under the house. Refer to photos. Person can crouch in certain areas and crawl in others. I’ve installed about 25 matts already but I’m inexperienced and therefore its time consuming for me, I also work full time during weekdays and my weekends are quite full.

The wire that connects the handle of my garage door to the latch has snapped. I think it can be repaired with a new piece of wire attached to the existing wire but I don't have the wire, joiners or capability.

Quote for rhe towel rack shown in the picture to be refixed please.

My kitchen sink has come loose and dropped from the benchtop cut-out. It looks like it may have been originally held with adhesive/sealant and possibly clips/brackets that have failed or are missing. I need someone to: • Securely re-fix the sink to the benchtop (using proper adhesive/sealant and clips/brackets as needed). • Ensure the sink is watertight and stable. • Supply any necessary mounting hardware (clips, brackets, adhesive/sealant). Notes: • The plumbing is still intact and connected. • Access under the sink is clear.

The front of the top kitchen drawer came off and needs to be fixed or replaced. The face has been removed and is in good condition as my housemate tried fixing it but did a poor job.

One sided niche install size ~900mm wide, ~300mm high Looking for someone to cut out, install extra timber, gyprock if required etc. I’m happy to do the finishing painting so you don’t need any repeat site visits Thankyou Joseph :)

Sliding door has become stiff, might need new rollers.

I need a number of vents removed and the holes replastered. Also so small holes in walls repaired from electrical work.

Need help installing some new licence plates on a car ASAP. Have screws and washers although unsure if they are the right materials. Additional required materials to be purchased by Tasker and will be reimbursed. Edit: they require 2 x M6 x 20mm bolts on the back only, front bolts already supplied

I need a couple things done with my chicken coop/area. I thought I had finished making it but a few of the buggers keep getting out 🙃 1. A roof (this will be done with just netting / mesh which I have already purchased (some of the chickens are flying over) 2. Moving the pavers that are on the grass currently to the gate (some of the chickens are digging and crawling under) I have attached a few photos. Photo 1 - you’ll see the first fence we put up Photo 2 - shows the pavers I’m talking about that will need to be pushed back onto the fence. But photo 2 also shows the added taller fence we added Photo 3 - just for fun. Added extras - if you are able to remove the veggie patch that is in there, and fix up the bricks around my (hopefully okay) Rosebush. That would be amazing. I have no idea on time and pricing, it shouldn’t be too hard of a job. I’m just too medically unwell achieve it myself, so would love the help. So please correct me if my quote is wrong as I am completely unsure. Thank you!