Find an experienced handyman in Evatt

Need someone to assist with slider door in picture it’s not opening smoothly not sure if runners etc

1) install 2x1400 curtain rod 2) install aerial silks to ceiling beam 3) tighten/add screws to wonky queen bed frame 4) fix loose door handle.

Install this pet door in a single pane sliding door. I have a glass cutting kit.

Removing a clothesline on 2 metal posts, each 1.78m high and dug into the ground. Possibly concreted in.

I have a shelf unit in my walk-in wardrobe which I would like to replace with a hanging rack. I would like someone to remove the 2 existing shelves and install the rack. It looks like the shelves are glued or nailed in (refer picture) so I can't easily remove them. I'm not worried about it looking pretty as long as it is functional. Width is 1200mm.

We're looking to have an external brick wall rendered. Measurements are approximately 5.3m (L) x 2.5m (H). We're looking for someone experienced in rendering. Happy for inspections of the wall if needed. Looking to have the job completed by 4 Jan 2026. Thank you

as mentioned previously happy to add photos soon

Needing my clothes line hung and drilled into the brick / wall will take 5 min if know what to do It’s 2 screws no offers over 60

I’ve got a 36v Hikoki impact driver (WH36-DC) that copped a hard life out bush. The housing cracked when it hit the ground, so I opened it up and did a bush-fix on the handle and wiring to keep it going. That meant warranty is void now. Here’s what happened step by step: Housing cracked, not covered by warranty. I used tabs and small screws to reconnect, which caused a short – fuse blew. Out bush without a fuse, I removed the fuse mount (instead of jamming a wire in – my bad). Tool resumed operation for a while. A thin tab later failed – replaced with roofing material, then another short on the ribbon wire. Repaired the wire, but now the driver acts like when the fuse was blown: light still works but motor won’t fire. I need someone who can diagnose properly, repair wiring or replace components as required, and get the tool back into reliable working order. What I’m after: Experienced with electrical repairs (power tools preferred). Home workshop setup is fine – not chasing brand-name repair shop rates. I’ll cover parts + your labour.

Need an installer to work with me at Evatt for a few days

Need a labourer to remove Gyprock from the ceiling and walls across three bedrooms, living, and kitchen areas. demolish bathroom and kitchen (remove tiles , vanity bath tub and toliet). its about 100m² Location: The job is located in Evatt, ACT. Specific Job Details: Schedule: I’m flexible Budget: Not Specified Site Visit: Anytime

Two plastic panels on shed roof have disintegrated over time and left holes in roof. I am not sure how much this usually costs so am open to offers

Need to put a sliding door back on track in the living room.

Looking to remove my current mailbox which is concreted into the garden bed and install a mailbox provided by me (pictured).

Need a handyman/builder to dissemble a van with annex and deck in Cooma and assemble in Evatt. The green patch on the left in the image below is where the house (van with annex) needs to be placed, and the one on the right is the home layout.

Dig two holes for clothes line Install Depth 500-600

I have a standalone stove top and oven appliance. One of the hinges on the griller door above the over door seems to have detached completely and needs repair.

Looking for someone to install dog door into laundry door. Dog door will be provided, and is shown in the images.

Installing 8 roller blinds. The blinds need to be cut roughly 5cm shorter in width indicated in the photo. Will be installing on wooden frames.

Main zipper unhooked on both sides