Find an experienced flooring expert in Gardiner

I recently replaced the flooring and now need to install new skirting boards in the kitchen. I would like to install stainless steel skirting boards in place of the existing ones. The kitchen is approximately 2.60 metres long and 60 centimetres deep. I can supply the thicker skirting board for the section next to the entrance door, as the gap in that area is larger than the others. I would need the remaining stainless steel skirting boards to be supplied and installed. I'm not sure how much this work would approximately cost, so I would appreciate an estimate and any suggestions or recommendations you may have regarding the most suitable materials and finish for the kitchen.

4-5square meter deck. Pressure wash and clean, sand and two coats of oil-based deck stain. We will provide the 1l tin to stain the deck. Masking and protection of rendered wall,down pipe and door threshold will be required.

I have found a stain in 3 corners in one room. I need someone that has the capacity to reduce and eliminate the stain.

I needed to chop the decking area of 3m x 3m I tried myself but the surculler Saw I was using has stopped working, I need it to be done today asap

I'm ready to hire a tradie to light sand and finish herringbone parquetry flooring in my single-storey house, covering around 90 sqm. with Bona water based 2 coats

Thorough sanding required as Decks severely weather beaten One Timber Deck at rear of house measuring 4.0m x 3.0m and a landing timber deck area near Porch Entry measuring 8-10 sqm. Total area nearly 30 sqm Thorough and Good sanding and preparation is a MUST. We want only Merbu Stain AND at least 3 coats applied as current coatings worn out. Please include all materials including cleaning solution, sand paper, Cabot Merbu stain, all applicators, protective cutting tapes etc etc in your quote

Nearly 70 sqm Enginered timber glue down with 3mm underlay,needs to take out the carpet as well,I will provide the glue. must have Public Liability.

We have hardwood floors polished and don’t want to redo we just want to make them look super tidy and clean/shinny.

I'm looking for someone to remove carpet and underlay from my floors and leave the surface ready for the next flooring installation/polishing of floorboards The job includes: Pulling up and removing the carpet. Removing the underlay. Pulling out all staples left in the floor. Removing any carpet tack strips/gripper rods around the edges (if applicable). Vacuuming the area clean once finished. Taking away and disposing of all carpet and waste. When? Any of the below options Friday 10 July - after lunchtime (we settle on the house at 10am) Anytime 11/12 July Living room 4.6 x 4.9 Bedroom 4 x 4.3 Bedroom 3.6 x 5.2 Bedroom 3.6 x 3 Hallway 10 metres long

Looking for a professional to come and sand and stain the wood along our pool and outdoor balcony

Site inspection to lay engineered oak herringbone flooring

Engineered Oak Flooring Installation – 170 sq/m We're looking for an experienced flooring installer to lay approximately 170 sq/m of engineered oak floorboards in our home, which is currently undergoing renovation. Scope: Herringbone pattern through main areas with straight plank borders Existing section: install over existing pine floorboards New section: install onto concrete slab Materials (supplied by us): Herringbone boards: 900 x 150 x 15mm Straight boards: 1900 x 190 x 15mm Happy to arrange a site inspection so you can provide an accurate final quote. Please include your experience with herringbone installation and availability when responding.