Find a professional downpipe contractor near you

I have recently had paving done at my house and the drainage pipes need to be cut down. 4 pipes in total

I have a down pipe that has clogged up causing an overflow of water near the connection into the drain near the base of my house.

Move down pipe to side of house and replace front gutter

I am looking for a plumber to do a few jobs at my house in Graceville. - connect 2 down pipes on the back deck. - install a 40mm back flush for pool - install 2 external taps for back yard (all roughed in). Need a form 4 for the work.

Restore eve sheet, clean gutter, fix dripping sound inside downpipe

gultter down pipe clearing, roof & valleys clipped repair

Replace section of downpipe - elbow to join vertical section….no painting required…

Carport has what I would describe as a rectangular gutter depositing into a standard down pipe. The gutter (circled in red) is leaking possibly due to rusting out over its 10 year life to date and I’m looking to replace

I have a small section of down pipe that’s rusted out and needs replacing on the second storey of my house. Doesn’t need to be colour matched. Just want it repaired so the water stops dripping down onto the shed roof. The section is only about 50-70cm. Can send photos

Recent windy storms dislodged the join in a downpipe on my highset home. I would like it repositioned and reattached permanently. It is on a front corner of the house with easy access.

Area of the roof that needs attention is around 50cm to 100cm, thats it I need flushing installed in the roof to direct the rain water path and protects insulation and plasterboard. I've got the flushing material already. Also, need a downpipe installed.

Adding one down pipe to gutter to prevent overflow with heavy rain. There is a drainage point about 3 meters away.

I need the pipe that’s feeding rainwater into our water tank to be diverted to pipe running out to street. Must be a qualified plumber have all tools and supply materials. Refer to photo / video. Should be a very straight forward easy job. Only an extra 4m or so of pipe required. Just want the job done properly.

So the gutter is not in the right angle and it accumulates water and dirt over time, need to adjust it to a right angle so the water will just flow and flush down the dirt and leaves when raining. May need to add additional down pipe if necessary

Remove dia 60mm downpipe and replace with dia 90mm x 2700mm length plus offset length into existing gutter.

Looking for a qualified plumber to complete two small plumbing/drainage repairs at a residential property in Margate. Both are above-ground PVC pipes and easily accessible — no digging required. --- 1️⃣ Garage downpipe – rear corner of garage PVC downpipe joint at the top elbow/horizontal section is leaking and showing mould. Likely cause: poor seal or misalignment at the elbow joint. Task: Inspect the joint and reseal or replace fittings as needed. Check that the short horizontal run has adequate fall for drainage. Ensure water discharges cleanly away from the garage wall/slab. Access: from ground level, right-hand rear corner of garage (see attached photo). --- 2️⃣ Under-house PVC drain (approx. 3 m run) Horizontal pipe under the house is installed flat with no fall. Task: Re-hang or re-support the pipe to achieve correct gradient (about 10–20 mm per metre). Supply new brackets/hangers as required. Confirm clear flow by running water through the pipe before completion. Good crawl-space access available.

Repair downpipes x 2. Seal flue on roof. I'm flexible with price.

The top section of my black downpipe has rust and bubbling paint where it connects to the box gutter. Need someone to clean and treat rust, seal any leaks, repaint in matching colour, and ensure it’s secure. Easy access.

See photos for more details. 1. Fix broken base for antenna on the roof 2. Resecure two panels fallen from the roof 3. Replace the down pipe approx. 5m tall (material to be reimbursed) 4&5. Repair of two small areas (approx 10cm x10 cm) of rotten timber on window frames (currently temporarily patched with filler).

Flashing needs to be done around an existing whirly-bird on a metal roof, and down pipe fitting needs replacing where the down pipe hits the pipe in the ground.