Find a reliable appliance technician in St Kilda VIC

Need someone to fix the kitchen dishwasher as it leaks sometimes and don’t turn on

Metal ring has come off. Machine leaking

Seeking a licensed gasfitter to decommission and take away a Rinnai Energysaver flued gas wall furnace from my apartment in St Kilda. Photos attached showing the unit inside and the balanced-flue terminal on the external brick wall. Scope: - Isolate supply and disconnect the appliance - Cap the redundant gas branch at the nearest practical accessible point (not just the appliance stub) - Pressure/leak test the remaining gas installation - Lift the heater off its wall bracket - Seal the redundant flue internally: trim the ducts back flush, pack ducts and the annular gap with mineral wool, and seal airtight with foil tape and sealant — not expanding foam alone. Finish flush or slightly recessed, ready for plastering. External terminal stays in situ as the weather seal - Remove and dispose of the unit (mostly metal, suitable for scrap) - Issue a Victorian plumbing compliance certificate for the gasfitting work Not required: - No external work and no ladder — the flue terminal remains on the wall untouched - Making good — I’m handling all plaster repair and painting myself Details: - Unit is plug-in via a standard power point, so no electrical disconnection needed - Easy internal access at floor level - Around 1–1.5 hours on site, plus cartage - Flexible on timing, weekday or weekend Please include your gasfitting licence number and confirm the compliance certificate and sealing materials are included in your price.

I put dishwashing liquid in my dishwasher and I need help ASAP it needs to be done before 6 PM ASAP

I have a washing machine that doesn’t connect to my taps. Need someone to help provide correct fittings and connect

Remove old washing machine and install new washing machine. Care must be taken not to damage cabinetry or floors.

Oven has gas connected but needs to be electrically wired in with new circuit. Switchboard is in the kitchen .

Cannot get washing machine hose onto tap. Won’t screw on properly. May need another hose or assistance. Water is still coming out if turn on tap

1.Replace the inner frame of Bosch serie 4 washing machine front door (as seen in the picture I have ordered the part already and its ready to be fixed) 2.Fix the door on the washing machine hinges properly 3. Test the washing machine and it should work as normal

Replace washing machine door seal on front loader. I have already purchased the seal. Im available Wednesday morning

Bosch Maxx 8 condenser dryer (WTE86302AU). The dryer starts normally, the drum spins and runs for about 1 minute, then stops and the “Container” warning light comes on. I have already: * Cleaned the lint filter * Cleaned the condenser/heat exchanger * Cleaned internal ducts and lint build-up * Unplugged and reset the machine The machine has been partially disassembled and thoroughly cleaned, but the fault remains. Looking for someone experienced with Bosch dryers to diagnose and repair the issue.

Bosch washer shows E18 error; drain pump filter cap stuck tight, likely blocked.

Assemble IKEA cabinet for washing machine (NYSJŌN) You must bring your own tools.

My washing machine won’t start a cycle, it comes up with a flashing light. I can’t see how to empty the drain as it’s normally located at the bottom right hand corner, but this washer doesn’t have that

Disconnected pipes, loose pipes, —

I have a dishwasher that was working fine but all of a sudden it is not draining. Likely an easy fix as it’s not even 1 year old but I’m unsure how to fix this!

Bra wire stuck in washing machine drum

Older decorative fireplace with SIT/Eurosit valve (photos attached). Has not been used in approx. 15 years. Needs inspection, clean, and safe restart. Licensed gas fitter required. Standard setup – photos included. Happy to pay extra if parts are required.

Have an Asko dishwasher (3.5 years old) that is displaying faults F10 & F11. Has been displaying F11 for a while but keeps working. Now the F10 is showing and not able to do full wash.