Find a reliable appliance technician in Pakenham

I have 3 cameras that needs to be mounted on brick wall. 3 holes each eufy s3 pro and eufy solocams. I have a ladder and the mounting brackets, screws and plugs. I dont have a drill.

Gas ducted heater keeps going off and you have to get in the roof and turn it off then back on at the switch for the heater to come on again.

The fridge is in need of a service as something is wrong with it. It works fine for a couple of hours then it trips the safety switch. Something is not right.

The heater system service - as spanner is showing therefore requires servicing. Gas cook top - The main burner on the left only partly lighting and it will not stay on.

im just after getting my roller door checked and a report written saying it’s been serviced/checked. I’m in pakenham

Install replacementment pump in Services Australia office. There is an old staton you open the door and remove 2 screws and then put the new pump in (This is already on site)

150mm range hood venting kit to be installed in a single storey house with cement tiled roof. Have Deflecto kit already so I will have everything a kit comes with from Bunnings.

Large amount of water entered our stove, need to check for damage

Oven door hinges are worn, door not closing fully, need help with repairs

When closing the oven door it’s little bit open not closing fully

Need wired cameras installed with motion sensors. Cameras required at the front, backyard and side walks of the house.

Oven door is not closing completly

Dishwasher has not pumped the water during a cycle the error code was EO1. Need fixed asap if possible before 10am tomorrow morning 9/7/25, thanks

Oven door doesn’t close fully

Oven door is not closing fully, need fix

I would like to install external 4 Security Cameras on our pre hardwired (cat6) 2 storey hebel home. The cat6 cable are hanging from their locations. I have purchased the Swann security system, and all the cat 6 cables are coming back upstairs to WIL where the security hardware will be sitting. Pls note about 16 cables which has come back in the WIL. I have pulled out 8 of them and crimped them ready to connect. I can pull out the other 8 and complete the crimping if required to make the job simpler. Once the 4 cameras are mounted and connected we just need to go upstairs and work out which of the 4 of the 16 cables are the actual ones connected, and connect that to the Swann hardwire. My main issue is that I dont have a ladder to access the external camera location points (about 3m above ground) and I not sure how to safely mount the camera to the hebel wall, also the external wires hanging out need to be crimped. So in effect I just need help with: 1. Crimping, mounting and installing the 4 camera in 4 existing locations (using a ladder) 2. Completing Crimping the cat 6 cable in WIL upstairs and working about which 4 cat6 cables are connect to the cameras 3. Installing the security system to ensure everything is working smoothly If you could please let me know if you offer which steps you are able to help with in your offer, 1 or (1, 2) or (1,2,3) Thank you so much

Emilia dishwasher blocked clean thanks

Looking for someone to install a dishwasher that I have and cut a small bit of wood for it to fit. Electrical work done. To the right is where the dishwasher would go. Sink is on the left.

My Garage Roller Door suddenly stopped opening up with remote, when you open manually, you can close down with remote but somehow not able to open with remote

Brivis ducted heater model zpw2o fan not working heater still lights up in the ceiling