Find a reliable appliance technician in Mount Waverley

Need a new dishwasher fixed ,might need to drill a small hole for pipe

Supply and install a GPO under bench for washing machine

Basically the dryer (TCE630 WP, 8kg) shows “Empty out container” about ~10 minutes every time I started a Normal cycle. I’ve emptied and re-seated the tank, cleaned both filters, and lightly cleaned the outlet. Note that the machine has no external drain connected. Only water tank. And every time when after it was stoped at 10 min, there are a little bit of water collected in the tank. I have tried to use empty water tank or 1/4 full, with or without tank lid. And I also replaced the plinth filter. The results are the same. I suspect there is a blockage of drain system inside the chamber, but open to diagnosis. Goal: Diagnose and fix the false “container full” warning, and service the unit so it completes full cycles reliably. Please include a 1-month workmanship warranty.

Im needing repairs to vending machine as it is not turning on .no power supply .

Replace Induction Cooktop (Same Model) Product: IKEA MATMÄSSIG Induction Hob 300 https://www.ikea.com/au/en/p/matmaessig-induction-hob-ikea-300-black-10467267/ Task details Need a licensed electrician to swap out my existing induction cooktop with a brand-new one — it’s the exact same model, already on site and ready to go. No changes to the bench or wiring setup should be needed. What’s involved • Turn off and isolate power • Disconnect and remove the old cooktop • Unpack, check, and install the new unit • Connect to existing wiring (hardwired) • Test that everything works correctly and safely • Quick demo of operation • Clean up the area and take away the old unit Notes • Easy access and parking available • Please bring your own tools and testing gear

I am after someone who can change my in-build gas oven to an electric one. Electrician (new circuit & install) Gas fitter (disconnection) Oven installation (labour total) Total estimate $400 Someone licensed please.

Fridge repair. Trip switch keeps going of when plugged in. Could be an easy fix. Not sure what it is though. Need help 🙏

SMEG DWAI6214X — Semi-Integrated Dishwasher Dishwasher is broken, pretty sure it’s the door latch. It’s registering as open but it’s closed. All we can do is power on power off. Can’t select any programs etc

move a dryer from mount waverley to warragul

Dishwasher repair - Haeir. It’s initially giving F30 error. We did the flood reset instructions and issue is the same. Also, sometime it trips the MCB. Its 1 and a half year old.

I have LG Dual door refrigerator ( it freezing the vegetables) i need to repair it may be some sensor need to be replce

Water drips out of the connection of the hose/tap for washing machine

To install outside camera

Moved house. Removalist didn’t connect washing machine properly. Leaking water. Please help.

The rangehood is Whirlpool WT9BTABC. Probably 1 year old. Seems like the motor is not working well, either runs slow or not running at all. Also it used to be very noisy, might be not installed properly as well.

My washing machine need a good clean up by lint removal. It's a Bosch machine

Our Blanco dishwasher is showing double digits next to the letter “H” that keep counting upward continuously. We are unable to stop it, and as a result, we cannot use the dishwasher.

Replace existing doorbell with chime with a new camera doorbell and indoor monitor. Airtasker to supply and install. The current doorbell has the following setup: Doorbell wiring- 12v transformer at sub board Figure 8 cable runs from sub board to indoor chime (loop) then from chime runs to the front door bell (tail)

I’m looking for someone with experience in installing wireless security cameras to help set up a system around my property. Job details: • Mounting X cameras (please bring your own tools – ladder, drill, etc.) • Positioning cameras for best coverage of front, back, and side areas Requirements: • Previous experience with security camera installation preferred • Own tools and equipment • Ability to provide advice on positioning for best results

I have four security cameras I need installing. One on garage and 3 around the house. All I need is someone to wire the cameras and run the Ethernet cable through the roof and into one of the cub boards. I don’t need you to program the cameras. Just wire and run Ethernet cables. One storey house. Will require a ladder.