Find a reliable appliance technician in VIC

Replacing my current ~53–54 cm freestanding oven/cooker with a 60 cm model. Need the left benchtop and its base cabinets moved left and the benchtop trimmed so there’s a 600 mm clear gap for the new cooker. Location: Nunawading What needs to be done 1. Remove base cabinets on the left side of the current freestanding oven. 2. Remove the left section of benchtop above those cabinets. 3. Reposition that benchtop further left along the wall (towards the door frame) to create space for the 60 cm cooker. 4. Reinstall base cabinets under the benchtop, starting from the new left edge. 5. Cut the benchtop at the end near the cooker so that, once reinstalled, there is a 600 mm gap between: • right edge of left benchtop, and • left edge of right benchtop (where the new 60 cm freestanding oven will sit). 6. Apply silicone sealant along the top edge of the benchtop where it meets the splashback. Assumptions / exclusions • Carpentry/benchtop and cabinet work only. • No plumbing or electrical work. • Freestanding oven will be disconnected/moved by me (or via a separate task); tasker doesn’t need to handle the appliance unless agreed. • Existing cabinets and benchtop are reused, not replaced • Small adjustments to align doors/drawers after reinstallation included. • Clean‑up of offcuts and reasonable job‑site tidy expected. What I’ll provide • Clear access to kitchen and cabinets. • Exact new oven model/dimensions before work starts (so the 600 mm gap is correct). Please include in your offer • cutting my benchtop type: • Estimated time to complete. • Tools you’ll bring (e.g. circular saw, jigsaw, clamps). • Photos of similar benchtop/cabinet relocation work if available.

My fisher & paykel dish drawer dishwasher won’t drain not sure if it’s a pump or a blockage . We have already replaced the Rotor

One of the stove coil is not turning off even after turning the switch to off for it, I think the fuse needs to be changed or check

Licensed Electrician to fix the Induction Cooktop Need an electrician to replace existing gas cooktop ( gas already disconnected) and install a new electric cooktop, including any wiring required. Appliance will be supplied.

Samsung fridge SR471LSTC, around five years old. Compressor works permanently without stopping. Ice built up inside the panel in the main compartment. Recently fan started making loud noise so decided to switch it off and defrost.

All running well except freezer does not freeze. Model No. HR6FDFF701SW

change the tempering valve for eneft EL320AIO HEAT PUMP 320L

LAVA brand vacuum seal machine V350.some of our items are unsealing when in the fridge after a couple of days. Require a service and check.

I need our clothes dryer put back on top of my washing machine (repairs were done today). My partner and I have bad backs and trying to avoid further injury. It should take about 10 mins in total. Between 10am and 5pm on Saturday (tomorrow) thanks.

I want someone who can remove the existing slideout rangehood which is connected to a duct as their is a vent outside and install a new slide out rangehood. Same size, nothing different just a new one.

I recently installed a new washing machine. One of the pipes underneath the sink is leaking, needs inspection, tightening/ resealing.

LG dishwasher stuck in error code “nE”. Serial number/model number in photos, need this fixing asap, located in our childcare centre. Current WWCC preferred but not essential.

Our dishwasher is not running properly. It’s a Bosch and comes up with the error code E4.

Recently changed door seal on my washing machine, worked fine for a couple of loads now it won't cycle at all and keep giving E12 error

Washer dryer combo won’t heat up when drying

I have a Samsung digital inverter powerjet 13kgs. I have taken out pump and cleaned it. Just don’t know how to put it back together.

I need help fixing washing machine

Asking machine stuck on spin and drain

Come and repair front load washing machine

Oven cooktop only 2 out of the 4 working ( Smeg)