Find local dishwasher installation experts in VIC

Need an experienced appliance repair technician to diagnose and repair a Fisher & Paykel DishDrawer. Issues: Stops mid-cycle and continuously beeps. Won't drain and is left full of water. Dishes have recently been coming out dirty. After resetting, it now makes a drilling/grinding noise during the wash cycle. Tenant has cleaned and reset the unit, but the problem persists. Looking for someone who can diagnose the fault and repair it. Please include your experience with Fisher & Paykel DishDrawers and advise if parts can be supplied if required. Location: Melbourne CBD Preferred time: ASAP. Flexible with tenant availability.

Office dishwasher not draining / washing. Fisher Pykle small dish draw. Need someone to attend in office hours.

Fisher & Paykel DishDrawer isn’t working. repeating 4-beep alarms in intervals. Heavy, lock and sanitise buttons illuminated control panel is unresponsive. Unsure of the model exactly suspected to be a DD6OSI, DD6OSTI, DD6OSLI, DD6OSHI or a DD60SHTI model Have turned off and on numerous times nothing seems to work. Doesn’t lock when closed either when turn on can hear it trying to lock but sounds odd. There is all bit of water sitting in filter but that has been like that since moved in over a year ago. Drawer is inbuilt I do not have any tools or understanding to get behind or fix etc so you would need to have supplies for that. As well as access to order parts if required. Thanks so much :) Wanting to get checked asap! :)

We have a Fisher & Paykel DishDrawer that after being installed has a fill? error for only the top drawer. The bottom drawer works as expected and there is only 1 water in pipe into the machine. There is no screen on the machine but error code is the ‘Heavy’ and ‘Eco?’ indicator lights on at the same time. Capacitive button to switch modes is also no longer working.

I have a new dish drawer dishwasher. Specs say it should fit the depth of my cupboards but when I installed it it’s sticking out a bit. I need someone to fit it properly and then tidy up the cabinetry around it.

I have a Fisher & Paykel DD60STI9 DishDrawer Dishwasher that stopped cleaning properly and then went into a fault state. It began showing flashing lights (Extra Dry, Quick, Sanitize) along with a red lock indicator and repeated sets of four beeps every ~30 seconds. I found water pooling at the bottom under the filter. I removed and cleaned the filter, cleared all visible water, and checked the pump impeller, which spins freely and does not appear blocked. However, the unit remains locked and beeping.

We have a Fisher & Paykel DishDrawer that after being installed has a fill? error for only the top drawer. The bottom drawer works as expected and there is only 1 water in pipe into the machine. There is no screen on the machine but error code is the ‘Heavy’ and ‘Eco?’ indicator lights on at the same time.

Red lock button is on and the dish drawer is not working.

Dishdrawer error codes - top and bottom. E2 O3 error code. Model: DD60DCX7

The dish washer has error f51 and the lower door is not closing easily. I understood from some search that the actuator cover might not be fixed well. I attached images for the cover on both sides to see the difference. But it is just a guess for the problem

My Fisher & Paykel DishDrawer dishwasher is repeatedly doing 3 beeps and won’t start a cycle. There was water in the bottom tray which I have fully dried, but the flood float switch is still stuck and the machine won’t reset. The drawer sits silent until I press START, then it gives 3 beeps continuously. I need someone experienced with DishDrawers to: • Pull the drawer out properly • Access the bottom tray • Manually reset/free the float switch • Dry underneath the float and switch area • Check for any small leak that may have caused the flood mode • Ensure the drain pump runs again and the machine starts a cycle normally No parts should be needed unless you identify an actual fault — this is most likely just a stuck float/flood error. Prefer someone who has worked on Fisher & Paykel DishDrawers before. Thanks!

Top dishdrawer is not draining, have been advised likely a simple fix but not game to do it myself

After using my dishwasher, the water will not drain. I cleaned the filter parts but that does not seem to work.

Dishwasher is not switching on

My Fisher & Paykel DishDrawer dishwasher has stopped mid-cycle and is constantly beeping with a red light. The rinse light is stuck on and the motor keeps trying to drain. From what I understand, it may be a flood sensor / water leak issue where water has collected in the base pan and needs to be cleared/dried, or there could be a small leak that needs fixing. Looking for someone experienced with Fisher & Paykel DishDrawers to: Check and clear the base pan (if that’s the issue) Diagnose the cause (leak, seal, hose, etc.) Get the dishwasher running normally again Must bring your own tools. Ideally available ASAP or Monday at the end latest.

Top drawer is stuck and won’t move. No error code (older model).

Our Fisher & Paykel dish drawer (single) works just fine IF you wedge a folded piece of cardboard under it. We’d like someone who knows and understands these dish drawers to fix it so that it works without the cardboard wedge.

Fisher Paykel dishdrawer clogged, disassemble the parts to check for clogged items but nothing found.

Fisher and Pykle DishDrawer on/pause button jammed, so unable to start the dish washer

I need a second hand Fisher and Paykel double dish drawer dishwasher to be installed and the top drawer filter to be correctly inserted (we can't do it for some reason!) so that it works well. The draining hoses need to be securely connected to under a mini laundry trough (it is busy under there!)as the current set up is leaking. If possible, I would like the dishwasher to be fixed to the cupboard. Work to be done Tues/Wed/Thurs afternoons or anytime Friday. I would love a plumber or ex plumber.