Find a reliable cooktop installation and repair service in VIC

Hi, I need someone to repair/replace my broken kitchen cooktop slab. It was purchased from domain

Need a licensed electrician to quote installation of an induction cooktop replacing gas cooktop. Please assess existing switchboard and provide the most cost-effective compliant option. Prefer to avoid unnecessary full board upgrades if possible. Gas line already isolated. Must be licensed and able to provide Certificate of Electrical

We are looking for swap over current gas cooktop

Existing kitchen countertop made from Caesarstone. Need 5-10mm cut off internal front edge of existing cutout to be able to fit a new induction cooktop.

Install a new circuit for an induction cook top BCI607B4BG - 32A RCBO. The electrical panel in the garage is brand new and has open space, the total cable run is less than 15M, and everything is on the ground floor. No need to do the patch work.

Only one cooktop can not ignite, fire can't lightened. may be due to clog or unclean stove. another 3 cooktop尸 can ignite. only one need to be fixed. Onsite fixing at Australis CBD Melbourne 3000 little lonsdale. Please provide technican proof and quote the rate, thanls

The gas cooktop (Miele) keeps ticking until we turn the power off.

Install a 90cm Bosch cooktop — the benchtop has already been cut to size and power is ready for connection. Also require installation of a Bosch freestanding dishwasher at the same property.

Hi, looking to get my 90cm Technika Gas cooktop replaced. I have already bought the cooktop. If you are available after 5pm today or tomorrow would be preferred. I am located in riverwalk Werribee Thanks

I need an A-Grade Electrician to do a quick site visit, inspect my property on Moncur Avenue, and provide a firm quote for running a new circuit and installing an induction cooktop. If I proceed with your quote, this call-out fee must be deducted from the final installation cost. The job you will be quoting on includes supplying and running a new dedicated 32-amp circuit from the main switchboard to the kitchen, taking away the old decommissioned gas cooktop, hardwiring a new Westinghouse WHI643BE 60cm induction cooktop, and issuing a Certificate of Electrical Safety. For context, the gas cooktop has already been completely decommissioned and safely capped by a plumber, and I have obtained the required VBA Gas Compliance Certificate. The switchboard has a solar array connected and space looks a bit tight, which you will see in the attached photos. I need you to check the property to determine the best cable run path and give me an accurate total price for the final job. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week for a quick look.

Need new 60cm cooktop to be installed. Gas pipe redirected behind plaster

Hi everyone, I am looking for a licensed plumber or gas fitter to permanently disconnect and cap the gas line to my broken cooktop so I can safely have an electric induction unit installed later. My current setup is a standard 60cm gas cooktop sitting directly above a Westinghouse electric wall oven. The gas is currently turned off at the main valve and the benchtop is laminate. I need you to safely disconnect the broken gas cooktop and permanently cap the gas pipe behind the oven. You will also need to test the line to ensure there are absolutely no leaks and issue a VBA Gas Compliance Certificate, which is mandatory for me to proceed with the electrical stage. Please leave the decommissioned cooktop sitting in the benchtop cutout once disconnected. My electrician will remove and dispose of it later to ensure dust and debris do not fall into the exposed oven casing in the meantime. You do not need to do any physical removal or electrical work. Regarding availability, I work from home most days, so my schedule is highly flexible for you to drop by during the week. Cheers, Sean

Looking for a licensed gas fitter to disconnect a gas cooktop and install a 1/2 inch gas cock to safely isolate the gas supply. Please provide a quote and availability, cheers!

Need someone who can replace my 900 Gas cooktop, please see the picture of old and new cooktop

Need to replace gas cooktop (like for like, new one provided-Westinghouse Model WHG644SC). Location is Melbourne CBD. Photos provided. Timing is flexible (other than Wed,Thursday and Friday day time), evening any day is fine though. Weekend is also ok. Prefer to also avoid very early morning.

Hi, I’m looking for a qualified plumber to assist with the disconnection and installation of a new freestanding dual fuel oven at my property in Gladstone Park. The job will need to be completed in two stages to allow for cabinetry alterations. Details of the Job: Stage 1: Disconnect the existing Smeg gas cooktop and oven. Discard the old unit if possible. Stage 2: Install a 90cm Westinghouse dual fuel oven once the cabinetry has been modified to create a cavity for the new unit. Requirements: Must be a licensed and qualified plumber. Experience with gas cooktop disconnection and dual fuel oven installations. Ability to coordinate and complete the job in two stages. Must bring your own tools and equipment. Location: Gladstone Park Photos: Attached to task Please provide an offer, and let me know your availability to complete Stage 1 as soon as possible. Thank you!

I need a compliance check for gas + fixes needed if required. Quote is for compliance check and fixes will be separately managed as needed

The gas cooktop does not ignite at times. When ignited and lit, once the knob is lifted, the flame turns off

Need instantaneous hws and gas cooktop installed today! Please offer for material and labour (I have units ready to go)

Need to remove gas cooktop, seal the gas pipeline and install electric cooktop if require installing new socket