Hire a reliable appliance service in Battersea

While doing drying. Showing F15 Error

Dishwasher powers on but dishes are not coming out clean. I was advised to use salt, but this did not resolve the issue. An initial inspection showed no error codes. On a follow‑up inspection, I was advised that the pump and thermostat likely need to be replaced. The correct parts were not fitted previously, so I’m now looking for someone experienced who can help complete the repair. Once we connect, I can explain the situation in more detail and show you the parts that are needed. Thanks.

We require someone to set up our Miele washing machine (WEA125WCS) and Miele tumble dryer (TEA525WP)

It's a counter top dishwasher. Need to fit it to the sink

My oven light is broken, I can’t seem to change it.

To install my electric cooker

Someone of my clothes were hanging whilst the machine was washing and it fucked the gasket. They machine works but the water leaks

AEG Cooker Hood Needs to be installed on wall, there no need of hood to be attached to chimney as there is no option just need to be installed on a new build flat

One of our storage heaters has stopped working, need an electrician to have a look at it

I want to get my washing machine installed in our flat. Not sure if you require any additional equipment for that. Also need a shower installation, for which we need to order or get products.

Remove old cracked induction hob and install new hard-wired induction hob (licensed electrician needed) I need a qualified and experienced electrician to: ✅ Safely disconnect and remove my existing cracked induction hob ✅ Install and hard-wire a new induction hob into the existing cut-out ✅ Test that the new hob is working correctly and safely ✅ Ensure the existing dedicated circuit and wiring are appropriate and compliant (like-for-like swap — same size/power) ✅ Provide any required paperwork or electrical certification if relevant 🔌 Important details: • New induction hob is already purchased. • This is a hard-wired induction hob installation, not a plug-in. • No major cabinetry changes needed (please confirm on site). • Must bring own tools and test equipment. • Please specify whether disposal of the old hob is included in your quote. Please confirm you are a licensed electrician, have induction hob installation experience, and your quote includes all labour/call-out charges.

Inspect existing ducted cooker hood (IKEA, ~10 years old) Poor extraction, smells lingering. Space width ~56 cm, duct goes straight up. Need advice on whether servicing is worthwhile or replacement options that fit

We have a space for an integrated fridge freezer and the company can’t install it because the base isn’t level (and therefore the doors won’t line up etc) and needs replacing. We need a new base installed so it’s level and ideally a new vent.

Hello, I am receiving a sensor error message on my treadmill. I have already replaced the sensor, but the error is still occu I would like a more detailed diagnosis to determine whether the issue could be related to the control board, motor, wiring, or any other component that may be causing this problem. Thank you .

Smashed the glass on my hob dropping a pan on it. have ordered a replacement just need someone to fit it and ensure it works and is safe

The washer-dryer is not heating. I tested the Cotton 60°C programme and after 10–15 minutes the door glass remained completely cold. It appears the heating element or temperature sensor may have failed. The machine otherwise runs normally and shows no error codes.

Need someone with experience of these ‘nu flame’ gas fires to get this going as has not been used in a long time. Have tried batteries etc and everything in the manual.

I’m want to get a dishwasher but need help in removing component of the cabinet where I will install dishwasher in order to get space required

Pressure gage not working and barely any water coming out of portafilter

Hot point washer door jammed shut mid cycle and get it open.