Find experienced local tradies in West Melbourne

Redo of unprofessional plastering job required. Just patch up no need to paint.

Install new single power point under bench for washing machine.

I have a garage ceiling that’s starting to sag slightly — no water damage or softness, just a visible dip. The house was built in 2006. The plaster is still firm to the touch. I think it may just need re-screwing and patching. Can you take a look and let me know what needs to be done and roughly what it would cost?

Install 6 downlights Install 2 power points Install 1 PAL outlet All downlights, power points and PAL outlet will be provided Downlights going on existing circuits Piwer points already exist on the same wall , need to add more

Need Power point in room.

Hi, I’m looking to have an additional power point installed on an internal plaster wall of my house. It would be located about 3-4 metre away from an existing outlet. Preferably a switch with USB (photo attached). Thank you

I require a registered Electrician to move a couple of power points. One is a little further along a wall, the other is to the opposite side of the wall (from bedroom to inside walk-in)

Need wall in garage to keep air out

Need to fix a number of hole in the roof plasterboard following the replacement of the older lights

Redo tv bracket so it’s higher above the power point

Looking for someone to supply & install a power point outside on our balcony, double story house. See attached electrical plan, Bed 1 Balcony - red circle is the preferred location.

My front and back door are stuck and hard to close.

Will need some drilled holes filled in on the wall. And painting some tiny areas in the wall in our rental. Needs a door fixed and the sink plug unblocked

Need below 2 external power points for future gate and water feature. 1. Front of the Home. There is external GPO in the facade- take line from that to until the front (6m) -  see photo 2. Backyard - There is external GPO- take line from that to until the Fence (6m) -  see photo There are trenches already 600mm deep. you may need to correct in some places a little bit. See photo Follow the electrical guidelines to comply with regulation and provide compliance certificate. Once work is complete put back the soil and tidy up. With Regards, Prabu

Add 2x power point and ethernet point at the back of the TV to hide the cables at the back. Currently the power points and ethernet are down below 300mm from near the floor and we need to add/raised those points at around 1600mm to be kept at the back.

I am looking to have 5 power points installed around the house.

2 clipsal iconic gpos to be installed and cabled 1 to a bathroom and 1 to a home office

Gyprock wall is broken. There is a hole in the wall. Need to repair and paint the wall. Handyman work.

Hey I need someone to install Sink Old sink seems to be smaller than cutout New sink may be oversized so need to cut stone if necessary I have purchased sink already

Need to add 3 power points, 2 behind TV that are wall mounted and 1 behind a floating TV unit. TV and floating units aren't mounted yet, need this to be done first. Need to supply power points.