Find experienced local tradies in Fraser Rise

Hi, I need help with someone supplying and installing 2x Clipsal Iconic double power points. You’ll be supplying all parts/materials required. Please quote accordingly.

Tradie Wanted – End of Lease Repairs ✅ Wall mark removal ✅ Minor touch-up repairs ( patch nail holes) See photos. Approx. 15 wall marks throughout the house. Must be available before lease handover.( 25th July) Local and reliable preferred

Seeking professionally licensed electrician to install 4 standard power points in our single storey house (built 2018), in Fraser Rise. Interior walls with standard timber and plasterboard walls; standard / high pitch roof with access to wall studs. Certifications required: A-Grade Electricians License and registered as a Registered Electrical Contractor (REC).

the front door, main bedroom and second living

3 power point to install

Hi, I’m looking for someone to remove an internal door and permanently close the doorway. Scope of work: • Remove the existing door and door frame • Build a timber frame inside the doorway • Install acoustic insulation inside the wall cavity • Close both sides with plasterboard • Plaster, sand and paint so it matches the existing wall The final result should look like there was never a door there (flush wall finish). Location: Fraser rise Please quote including labour and materials if possible. Photos attached for reference.

need a power point and connection for electric cooktop in the kitchen of a new house from the main line .

Looking for a qualified electrician to install a power point next to bathroom sink

need double points installed . 2 double power point switches downstairs. one double power point in the bathroom upstairs.

Need Rendering for external wall. Location: Fraser Rise, VIC. We made an extension wall in Alfresco. Need to do rendering. Area Approx: 15 Sq Mtrs.

Facade render clean due to moulded stains.

Hi, I need help with someone install a side awning for me to provide a shade for solar batteries. This is the awning I have bought: https://www.kogan.com/au/buy/yarra-supply-instahut-side-awning-sun-shade-outdoor-retractable-privacy-screen-2x3m-grey-42003330433106/ Photos have been attached to give you an idea about the awning and location where it needs to be installed. Please see the other side of awning needs to be installed on part that has pebbles. I’ll supply awning and bolts that came with it. Any other material required will be provided by you. Open for reasonable offers.

We require a double internal garage plastered over brick veneer. Must be qualified and provide references

Repair a hole in an internal wall. Needs plastering and painting .

I need 2 Power points installed. One on my bedroom wall for a TV, and one in lounge room for fish tank. Double sockets for TV and 5 or 6 Port for fish tank wall.

We are seeking quotes to cover the following services: 1. Install x2 new power points in our theatre room. (Closest existing point is behind this wall, at a right angle, on the exterior wall) 2. Install x1 new power point in our laundry room. (There is already one there at a higher point on the wall, the new one would go directly below at the standard position) 3. Replace existing ceiling lights from standard bulb fitting to downlight fittings: x1 toilet room, x1 bathroom, x1 wardrobe Note: The wardrobe light is desired to have a motion sensor capability (if possible, based on advice and estimate). I already have downlights so should not require quotes to include these parts (with the exception of advice on motion based request in the wardrobe). Single Storey House with colorbond roof.

Redo tv bracket so it’s higher above the power point

I require a licensed electrician to install two lights and two power points.

Need my retaining wall re-rendered. I tried to DIY and couldn’t quite figure it out. Can supply render for job. Just need to know much much to purchase. Have some of the Davco Off White Render left. Length 3435mm by 2345mm Height at highest point is 480mm, lowest is 220mm. Cheers.

Window awning jamming bottom left, hard to open if i fully close it.