Find experienced local tradies in Outer East Melbourne

Kitchen ceiling needs plastering due to holes made

Repair base of awning on caravan where rivets have come out .need to insert 4 x 6.4mm diameter heavy duty rivets . It has been removed and holes drilled out. All that is needed is to reattach the foot with the heavy duty rivets . You will need to bring the rivets and tools. Opus expedition max caravan

Hi, I’m looking to get a power point installed and was wondering how much it would cost. It’s a double-storey house, and there is no point near by but there is already a power point on the other side of the wall in the garage. Could you please provide an estimate? Thanks!

Need an experienced handyman or signage installer to mount and bolt rigid signage panels across the upper-level balustrade/verandah posts (see attached photos). Scope of Work: Securely mount the signage panels to the existing steel posts/uprights. Hardware requirement: Fasteners must be installed with washers (as shown in the reference photo) — please use rubber/neoprene protective washers against the steel posts to prevent scratching/corrosion, and wide/square load-spreading washers on the front to protect the sign face from damage and wind pull. Ensure the sign is level, plumb, and firmly fastened for outdoor commercial exposure. Clean up any metal shavings or packaging on completion. Access & Site Details: Location: Mount Evelyn, VIC Dimensions: Sign is 7m × 1.8m (3 panels). Supplied vs Required: Supplied by owner: Printed sign panels on-site (3 vinyl banners). Tasker to bring: Heavy-duty cordless drill/driver and metal drill bits. Appropriate outdoor-rated fixings (bolts, nyloc nuts or metal screws, square/wide washers, and rubber/nylon protective washers). Appropriate ladder or safety step equipment if required. Please specify your experience with signage or metal bracket installation and confirm whether you will supply the bolts/washers when submitting your offer.

Install awnlux awning onto 5th wheeler

**Title: Plasterboard Repairs and Ceiling Renovation – Kitchen** I’m looking for an experienced plasterer to repair the kitchen walls after the old kitchen was removed. There are several holes and damaged, uneven areas in the plasterboard that need repairing. The existing ceiling also has cracks, and I’m not happy with the previous repairs. I’m considering having the kitchen ceiling redone, potentially replacing the plasterboard, rather than patching it again. I’d like someone to inspect the job, advise on the best approach, and provide a quote. Location: Croydon, Melbourne. Please let me know your experience and availability.

Minor plastering work needed as other tradesperson took a break. Need to get the plastering work done quickly.

Need an existing awning window chain winder replaced with a Whitco lockable winder. I can supply the winder or please quote if you prefer to supply and install. Also, lever sets on two bedroom doors are not latching/closing properly and need to be adjusted so they shut smoothly.

Need to patch a hole in the ceiling, approx 34cm x 27cm

Looking for an experienced handyman/plasterer to repair two ceiling plasterboard holes: one small hole above/inside a window frame area and one larger rectangular hole in the bedroom ceiling. Existing plasterboard is 13mm thick. Patch, sand and finish flush with the ceiling, then prime and apply local touch-up paint to blend with the surrounding ceiling. Tasker must supply all materials, paint and tools. Please protect floors, furniture and window furnishings, keep the house clean and tidy, and remove all waste. Must complete the job within one day on Wednesday 7 October 2026. Photos can be provided.

Install two DIY 1.5m x 3m awnings on side of house. Awnings come with screw packs. Side of house width is 2m

Three power points in the wall needing fixing.

2 of the bedroom robe interiors are demolished and newly installed cabinets. Plastering work needed to fill the gaps, dents and cracks on the interior robes. Couple of hours job for an experienced plasterer. Need this done before painting works to commence.

Some plaster finishing & cornice work in a kitchen in preparation for painting. All new plaster is already on, work is only finishing to smooth with some minor cornice work. I have all materials on site except for the cornices.

Paint exposed timber trusses undercover on my verandah. Approximately 6 trusses in ‘Paperbark’ colour. Also paint the trim of the carport in the same colour.

Hi, I’m looking for an experienced plasterer to repair a hole in the ceiling where an old heater/chimney flue has recently been removed. The flue has already been taken out. I need someone to: Patch the existing ceiling opening Install any necessary backing/plasterboard Plaster and finish the area properly Sand it smooth and leave it ready for painting No painting is required, as the ceiling/walls will be painted separately by another tradesperson. I’ve attached a photo showing the current condition and size of the hole. Located in Mooroolbark. Ideally I’d like someone experienced with ceiling repairs who can provide all necessary materials.

Need a wall signage removed and wall plastered

Put power point for outside in brick and in an inside cupboard

As stated, I’ve removed a tall wall heater. The remaining cavity is about 1600x400. No painting required. I have some timber lying around for mounting.