Find experienced local tradies in Sydney City CBD

We’re vacating our retail shop and need the walls tidied up for hand-over. Scope: - 20-30 tiny picture-hook holes (≈1 mm) - 10–12 slightly larger holes (≈10 mm) Task: Fill, sand flush, and paint to match existing wall colour. Date: Tue 23 or Wed 24 July (must be completed on one of these days). Location: Paddington.Parking is available

1. Cut gyprcok wall (direct stuck to block wall) 2. Install 10 angles (needs to be level for 2x shelves) 3. Re-plaster around angles / set and sand ready for paint. Only materials supplied will be angles, fixings for angles and plasterboard.

I need you to assemble and install two infrared saunas. You must have experience. They come in seperate pieces and need to be put together. You need to have your own tools.

4 holes of varies sizes in drywall required to be patched.

Wall Rendering requires where Wall removed

We need 1 row of bricks laid that is roughly 2-3 metres long. Photo will show what needs to be patched up under ceiling line, the wall is obviously brick above ceiling. We’ve jackhammered for a penetration above ceiling and cracked some off below the ceiling tile line so our task is get a brick layer to lay 1 row of bricks 2-3 metres long. Then to render to cover the chips underneath ceiling tile line. It’s imperative that the work is clean and the work area is protected as there is carpet and it is a finished office building on Bridge Street in the city. Please allow in your price for parking as it’s the city and you’ll need to pay for parking. This is an urgent job, we need it done some time tomorrow if possible. I’m putting this task up again as the brick layer that was supposed to do today pulled out on us.

Suburb: Sydney, NSW, 2000 Date of Work: Saturday, 7th June Looking for a licensed electrician to install three (3) power points on a gyprock wall. There is already an existing GPO on the opposite side of the wall. The wall is standard gyprock. See attached reference image for the exact wall and the exact highlighted area. Please bring all necessary tools and materials.

Need to get holes patched (see picture) Aprox 15 m per wall Will pay cash

2 x patches where gyprocking has been cut out need fixing. 1 x area is approx 40cm x 40cm and has existing gyprock piece, no need to bring your own 1 x area is approx 3 m long x 15cm-20 cm wide, you may need some offcuts patching and 1 coat of paint required (ceiling white or similar)

Need carpenter to put 75 inch TV on GYPROCK wall. Please give quotation with materials with finishing all necessary tast involved in it. As wall is not concrete. Location: 45 Shelley st, Sydney NSW 2000 CBD (Lift & Parking available)

Looking for a tradesmen carpenter or apprentice carpenter experience in door n Fixout easy and constant work paid weekly

I live in an apartment in the city. There is a hole in the dry wall which will need to be filled and painted over (white). See images. Please bring your own equipment and materials.

Install two PowerPoints into a kitchen at a cafe. Current power points have deteriorated.

Two PowerPoint in a cafe kitchen require inspection testing and replacement. Not sure of AMP - assume 15A. Both are similar - face plate has deteriorated and requires a new one alongside fixture.

break a big mirror and remove it from a plasterboard wall. 61-63 market street Sydney 2000

I need a the supply and installation of four angles for columns, each 2700mm in height. Only four angles are required. We will handle the sanding after you set, so your quote should cover supply and installation only and setting. It’s a job that should only take a few hours.

Need an Electrician ASAP to replace a faulty control box for an infrared sauna. New electrical box available, just need to get someone to install it today! Location: Pitt Street Sydney 2000

Render a damaged render and Brick wall.

Need a Arch rendered and also 2 walls arch is 2.8 long 1.8 high 350 deep walls are 2m x 1.2 inside out. 2 walls

Miscellaneous patching and plastering