Find a professional Villaboard contractor near you

Looking for someone to install James Hardie Villaboard in a bathroom renovation in Watsonia. Bathroom is approximately 2400 × 1800 mm and has been stripped back to the studs. Framing is complete. Need Villaboard installed to all walls, including neat cut-outs around the window, door and plumbing. Villaboard will be supplied.

Sheeting bathroom walls and ceiling.

Looking for a carpenter/handyman. To quote for villa board sheeted in bathroom, small timber corners and skirting boards and make some cupboard doors In the laundry.

A carpenter has just finished putting in a couple of walls for a new bathroom in my granny flat and now I need someone to plaster the board gaps. The walls will be painted over and not tiled over and the walls are villaboard not gyprock as it is a wet area. I have hardies joining compound base coat and top coat plus a couple rolls of joining tape if needed. If you want to use your own materials that is completely fine as well.

Repaint villa boards front at house that has faded from the Sun Colour: Monument grey We will supply paint if you can supply all other equipment. It’s 2nd story Front face and right hand side face Approx 40 sq m

Need 2x 1.2 nib walls sheeted Either villaboard or aqua check Gyprock works Tasked must supply and install

A price for a carpenter, remove sheets, and sections highlighted only, with mould shown, and replace with Villaboard or similar waterproof product.

Hi, I need two sections of villaboard replaced in my laundry. Roughly, 500x600 and 600x600. Note; the taps you can see in this picture won't be there when you do the job. Also, Im tiling over the top so you don't need to give it a complete finish - Im just looking to basically repair this area but I wanted villaboard there as the area is located behind the laundry sink.

im sheeting this carport roof over the next week or 2 with villaboard, just looking for a young bloke to give me a hand or 2, someone experienced on a day rate might have a lot more future work here and there as well.

**Experienced Gyprocker / Plasterer Required – Outdoor Villaboard Pavilion** **Location:** St Ives, NSW 2075 I am looking for an experienced gyprocker/plasterer to complete the finishing work on two newly constructed outdoor Villaboard pavilion screens before painting. **Work Required** * Tape, bed and finish **2 vertical Villaboard joints** (each approximately 1.8 m high) * Sheets have been installed with an **approximately 5 mm gap** between boards to allow for proper tape and setting compound * Fill approximately **90 countersunk screw heads** (around 45 per screen) * Sand and feather all work * Leave ready for primer and paint **Materials Supplied** * Villaboard joint tape supplied * Large tub of filler / compound supplied * Structure fully built and ready to work on **Important** This is a feature structure within a recently renovated pool and garden area. I am looking for a **high-quality paint-ready finish** where the joints and screw heads are not visible after painting. Please only quote if you have experience with: * Villaboard / fibre cement sheeting * Joint setting and finishing * Achieving a professional paint-ready finish I am not looking for the cheapest quote. I am looking for an experienced tradesman who takes pride in their work and can deliver a quality result. Please Provide Phots of your work. Thanks Stephen

Bathroom renovation needs villaboard resheeting 48sqm including around inset bath, shower nook and lower edge of skylight. Square set for floor to ceiling tiling. Villaboard supplied needs fasters etc.

Need sheets installed i will supply everything

I need to patch my wall in my bathroom with Villaboard plus paint the wall

Plasterer needed to set joints in villaboard of approximately 32 meters of recessed joints in walls and ceiling and one external corner 2ms high and 4 internal joints.

Supply and install 6mm villaboard to shower area to cover existing plasterboard. Cut holes for mixer and shower head and position approx 2mm above shower tray.

Cover existing glass splashback with villaboard then tile over with Kit Kat style tiles. Splashback is 690mm x 2190mm.

I have 3 bedroom , 2 bathroom and kitchen which needs villaboard fixing and use of acoustic clips in ceiling . Would prefer a fixed quote but happy to discuss day rate as well . Old sheeting has been removed and its ready to work on. Happy to work with apprentice as well.

Need to replace a villa board sheet which was damaged

Looking for an experienced plasterer/handyman to install Villaboard on my bathroom walls. Approximately 10 square metres. I can supply the Villaboard. Ideally would happen this Wednesday but can be flexible for the right person.

Description: I need an experienced handyman/plasterer to tape and set a joint between Villaboard (fibre cement sheet) and plasterboard in my bathroom. Scope of work includes: - Preparing the joint between Villaboard and plasterboard - Applying joint tape - Setting the joint compound suitable for a bathroom/wet area - Sanding to a smooth finish ready for painting or tiling Details: - Small job, single wall joint - Materials can be supplied by you or I can provide (please specify in your offer) - Must have experience working with Villaboard and wet area finishes Location: East Maitland Timing: Flexible, ideally within the next couple of weeks Please include: - Your experience with similar jobs - Whether materials are included - Estimated time to complete