Hire an affordable handyman for any job in Hillsborough

Gyprocker required to do 30m of square set in a garage.

I need someone to resheet the ceilings of a few rooms in my house and patch up ready for painting. There are light fittings and ducted ac vents that will need to be cut into new sheets also. Can’t just re-pin the old sheets either as they are old and fragile, old sheets will need to be taken away also. If you can help please drop me a line. Also flexible on dates can be done essentially anytime this week.

Hi Terrance Are you still able to stop by tomorrow to install the door jam

Set plasterboard joints 6x6m ceiling.

i need someone to remove 1m3 of plaster board, 3 wooden doors , 2 sliding door panel and 10 cabinets drawers and side panel

Have 3 and a half concrete ramps to be jackhammered. Must have own jack hammer

I need a carpenter to help with this task: Job 1: Ceiling panel above garage door dropping jamming roller door at times. Need the garage door removed and then replaced after ceiling has been refixed to joists etc. Job 2: Cut a hole into the ceiling to allow for a drop down attic ladder in the garage, fit whatever support around the hole that is required for strength, measure and cut to fit flush hinged a hatch (made from white melamine board to match white ceiling). Can be cut first to allow access to Job 1. Additional notes: At least a ladder or two, and what ever tools tradesman needs for the work. I will buy the board, hinges and lock for hatch. (i hope the tradesmen would visit to inspect job prior to start if i accept quote. This task was created using a Template. You can still ask questions and make offers as you would on a standard task.