Find an experienced flooring expert in Sydney

Description: I’m looking for an experienced decking professional to supply and install a new deck in both my front and rear small courtyards. Scope of works: * Total decking area approximately 18–19 m² * Supply and install a basic, good-quality decking material (open to recommendations) * Construct a neat, level, professional finish * Remove and dispose of any waste upon completion Requirements: * Proven experience building residential decks * Please provide photos of previous decking projects or a portfolio of similar work * Must have appropriate tools and experience * Preference will be given to experienced tradespeople with strong Airtasker reviews Please include in your quote: * Estimated timeframe * Earliest availability I’m looking for a quality finish at a competitive price.

We need an experienced timber finisher / carpenter / flooring professional to sand, stain and clear-seal approximately 6 metres of raw 12 x 12 mm clear-pine tri-quad scotia. This is finishing only — the scotia does not need to be cut, mitred or installed. The goal is to get the visible curved face of the scotia as close as reasonably possible to our existing light warm-oak engineered timber floor. We tried one test section using Feast Watson Prooftint at full strength and it came out far too dark, so we need someone experienced with staining pine to properly test and control the colour before proceeding with the full lengths. We currently have: * raw Porta 12 x 12 mm clear-pine tri-quad scotia — approx. 6 m total * Feast Watson Prooftint timber stain * Feast Watson Matt Clear Varnish * 220-grit sanding sponge * timber finishing brush We believe these are the main required materials, but please advise if a timber primer/conditioner, colour reducer, different stain shade, or other preparation product is needed to achieve an even light-oak result on pine. Please include any additional material cost in your offer or discuss it with us before purchasing. Scope required: * inspect/test on an offcut first and confirm the proposed shade before completing all lengths * lightly sand and prepare the pine * apply stain carefully so it is light, even and not blotchy * apply appropriate clear matt protective coats, with light sanding/de-nibbing between coats where needed * ensure the finished pieces are dry enough to be handled and installed later Please only make an offer if you have experience with staining clear pine, timber trim, skirting/scotia or timber colour matching. Photos of similar work or relevant reviews would be appreciated.

Lay engineered floorboards. Will need some carpet and tiles removed. Price includes cost of boards.

Collect and install engineered timber flooring. The boards will be pre paid for. Remove, carpet and tiles, then lay the boards. The space is aprox 19 square meters. Tiles to be removed 1.5 square meters. Install level boards with scorcha.

I need an experienced Hybrid flooring tiles installer who can install around 80 sq meters of hybrid locking style tiles on a floor and a small damp area and four steps.

Fix window, put eves up, lay floorboards, install doors and slider door hardware

I need vinyl floor layed 6 rolls 105.85m2 We supply vinyl

Remove carpet and lay hybrid flooring for 1 living area and hallway. approx 25m2. Please provide quotes. I can provide an example of what flooring I am looking for or alternatively purchase and supply

Need experienced installer for hybrid flooring in small studio apartment (16–17sqm) - Wide planks (225mm) - Scotia trims - Flexible install date - Looking for clean professional finish - Onsite parking - Please send quote - AI generated picture of end result (1st is current 2nd is the result)

Hi, I'm looking to get a quote on a possible vinyl floor installation in my apartments bedroom. Address: On Castlereagh Street, Haymarket, sydney. Rough Measurements : 4.75m Length, 4.25m Wide I live in this apartment and have gottena approval from the apartment owner. I need to also get my building managers approval before work commences. I've already removed around 50% of my rooms carpet and planning to remove the rest by myself, so was wondering if i could get a quote excluding / including carpet removal costs. And does the quote include acoustic underlay?( or material needed between the vinyl and cement flooring if its required). I'm looking to complete this full renovation as soon as possible within the next few weeks

Installation of hybrid floor board for the kitchen and corridor. The materials will be provided. BYO tools to cut.

We are looking for an experienced installer to lay vinyl plank (or hybrid) flooring in a small takeaway shop. Details: Area: less than 35 sqm Existing floor: see the pics attached Work required: Install flooring Clean finish around edges (minimal gaps, neat look) *Labour only Other notes: Prefer someone with shop/commercial experience

I'm looking for someone to lay floorboards (engineered wood - oak: Havwoods brand) in a standard bedroom. Approx space is 12sqm. Carpet has been removed and the laying surface is concrete. We have the floorboards and glue so just need someone who knows what they are doing to install them correctly! It's a freestanding house and easy access to a ground floor bedroom.

Hi, I’m looking for an experienced installer to lay floating laminate floorboards in a studio space in Surry Hills. Scope: 2 rooms: approx 75sqm + 70sqm (145sqm total) Installing floating laminate flooring Subfloor is yellow tongue Both spaces are open and relatively straightforward Flooring: Floorboards will be supplied (likely 12mm laminate) Installation will be over yellow tongue. Please include in your quote: Installation only cost with scotia and without (per sqm or total) Estimated timeframe to complete Experience with laminate / floating floor installs Please note: I’m comparing a few quotes and looking for a fair, competitive rate for a straightforward install. Please include: Whether you are insured Any workmanship warranty offered

I need removable stair treads installed (no permanent glue) on mixed triangular and straight steps. Needs to be cut to fit 19 steps

Looking for someone to install around 6 m^2 of flooring. Around 6 rubber tiles and 1x1x0.1m at our Killa boxing gym in Marrickville nsw 2204. We have around 4-5 tiles that are under the boxing ring but might need 2-3 more for installation. We want them glued to the concrete floor if necessary. I need an aluminium step around the water bubbler to avoid spills damaging the rubber flooring. Price includes any extra tiles required if you can supply, Aluminium step around 3m long if necessary and glue

remove old carpet and install new Vinal flooring to 4150x 3100 aria

Hi! I need someone to remove my current vinyl flooring in my studio kitchen (about 5sqm) I then want it replaced with another vinyl flooring (Karndean Opus Stone Terra) I will supply the vinyl. Just need removal of current vinyl and installation. Floor might need some levelling. Looking to have this done well please! All offers considered :)

PVC sheet laying for the whole room with carpet, it’s rental property so I can’t remove the carpet, so install the PVC sheet on top of the carpet to become waterproof.

Looking for a flooring professional to: * Remove & dispose of existing carpet in two rooms (photos attached) of an empty unfurnished apartment (total area approx. 27sqm) * Prepare subfloor as required * Supply and install appropriate acoustic underlay * Source and install hybrid wood flooring * Install trims/scotia as needed for a clean finish
 * Ensure installation meets standard NSW requirements & give me proof ideally Site Details: * Located by Waterloo Metro * Ground floor apartment * Flat easy access * No dedicated parking spot, but street parking available nearby * Two rooms to do (total approx 27sqm) * Existing flooring: Carpet
 Please include in your offer: * Confirmation you can provide certification of the NSW standards met * Estimated timeframe to complete Thanks in advance!

Hi mate, I have a client asking for floor sanding and polishing. They’re hoping to start around the end of next week, beginning of the week after. Access for inspection/quote can be arranged from July 2 through someone who has the keys. Can you please let me know if you may have availability around that time, and what info you need from me for a quote? The total area approximate 50 sq.m. Thanks, Alex

Hi, We need a French polisher to touch up wooden floor boards and combiners. We assume the whole job will take about a day. Regards

Hi, We need a French polisher to touch up wooden floor boards and combiners. We assume the whole job will take about a day. Regards

The kitchen and entryway of my new apartment has parquetry flooring which I would I think I would like sanding and polishing. There is some discolouration where the fridge must have been which I think is water damage although unsure if it can sanded out. Otherwise there is just general wear and tear.

Small office in Sydney CBD with four meeting rooms and an open area. Task is to clean and polish aluminium skirting boards around the office. Steps: • Clean metal skirting • Remove marks or residue • Polish, wax and buff Products will be supplied. Needs to be completed before 5pm Sunday. Easy access office building with lift.

Floor sanding and polishing to a natural matte finish: -65m2 -Can be present at site on 26, 27 Feb to provide inspection -Old carpet strips will be removed. May need to remove some old staples from previous carpet. -Broken floor boards will be replaced by others. -You can start earlier to prep (while painting is being completed). Need to move-in on 7th March Please send through previous work photos.

Wanting to get my kitchen benchtop polished and resealed

Sand and polish my floors. The kitchen and living room built in cabinets will be removed as part of kitchen reno. The floors must be done between the strip out and installation. This will happen in next 5 to 7 weeks, dated TBC. Floor layout requiring sand and polish is marked in brown in the attached image. Floors of the bedrooms are floating hardwood and are cracking, if possible cracking should be fixed. Bedrooms do not require sand and polish.

We’re looking for an experienced timber floor professional to rejuvenate (oil polish) our hardwax-oil timber floors — no sanding. Details: • Engineered European oak parquet (Tongue & Groove – Raba) • Finish: WOCA Hardwax Oil • Area: ~28 sqm (living room + kitchen, open plan) We already have the WOCA products (Intensive Cleaner + Maintenance Oil). We’re looking for someone with the correct polishing/buffing machine (rotary) and experience with hardwax oil floors to do the clean + oil rejuvenation properly. Please let me know your experience with hardwax oil floors, the machine you use, and your quote.

Had some scratches patched on a black wooden floor. But when dried has left these unattractive marks on floor from previous handyman. These need to be polished to leave a better result. About 4 spots. The pic is of the largest one. Approx 60cm long. Must be done on a Thursday please.

Potts point studio apartment (25sqm) has old pine flooring that hasn’t been touched in 20+ years. Looking to have the floor restored, sanded and polished. Date flexible Thank you!

timber floor area is about 35 sqm (living-dining area and study), it's currently quite dark and I would like to make it as light as possible (but not whitewash) and have matte finish

Sand and polish timber floor(28sqm), plus 13 stairs(no landing and I will remove all carpets)

Looking at someone to come and repolish the wooden floor in our hotel lobby. Looking at removing some floor marks and make the wood shiny again with a good professional clean.

Please provide quotation (per Sq Meter), thank you Sand, stain, polish (water damaged), kempas floating hardwood flooring. Room size approx. 2.5 x 4m

Floorboards sanded and polished

Clean and polish decking: Remove and stack sections of timber decking (deck is approx 2.5x4m) Clean /gurney white tiles underneath timber decking Seal up any holes on each side of deck floor Replace timber decking Gurney clean top of timber decking Mend any broken timber slats Polish timber decking Could be done over two half days work to allow decking to dry before polishing on second day. (Provide own gurney, tools to repair some of the timber slats that have come off, sealant to fill holes, and tools to polish the timber decking (polish will be provided)

Please level and then give this floor a polished concrete finish. It is approximately 15 square metres.

Polish my garage floor. New concrete slab was poured 2 months ago. Burnished and smooth. 29 square meters total.

Floor boards need polishing

Recently removed carpet from hardwood floor which needs to be refinished. Two bedrooms (10.5 sqm each) plus hallway (~3 sqm). Will add photos shortly!