Find an experienced builder in Sydney

Replace 4 old hinges with 4 new suppied hinges on driveway gates. The new hinges are larger than the old hinges so new holes need to be drilled into the wood I am available to assist if needed and amavailable on Wednesdays and Fridays

Help builder ripout kitchen and break up a tiled floor. I have all tools needed.

90% done, don’t have the skills or tools to finish the adjustable top of the door and add weather slides. https://patiolink.com.au/installation/

A bedroom in our house is significantly colder than the rest of the house. I am convinced this is coming from a draft but cannot find the source. We have sliding doors and windows that fills the entire external wall of the bedroom so this is likely the area. There is also a HVAC system. We need the draft found and sealed so that heat does not escape and cold air come into the bedroom.

Demolish two story section of house

Hi - we need a handyman/ builder/ plaster to seal up the vents in two rooms that are causing noise and drafts to enter the house. We have 5 vents in total

1. knockdown half wall, 2. build 2 walls plasterboard 3. add 1 bathroom

Help wanted for a builder to fix / build floor for a small bathroom. See also frame task request.

Looking for quotes to cat net/proof my outdoor patio

Blue paint stain on driveway to be removed.

Fascia of eaves of front of building - like for like shade Woodland Grey. ground floor only Pergola at rear of house - like for like shade -Woodland Grey and shale grey

existing brick chimney abuts adjoining house which is taller - chimney has a down draft because of air pressure created - needs flu extension on top of chimney to go above adjoining house to prevent down draft. There has been one in the past as hooks still on side of adjoining house.

1. Qualified person to build a second bathroom upstairs in a heritage listed terrace 2. Must understand requirements and legal boundaries 3.Experince lodging DA with Sydney Council 4. Budget provided

We bought this one: https://easyshed.com.au/products/flat-roof-garden-shed-3m-w-x-1-5m-d-classic?_pos=1&_sid=bab9ef464&_ss=r&variant=44452581048479 And need to have it installed inside our office area in Alexandria. No anchoring into the floor is required, just the installation without damaging the walls in our office. We would need a quotation for it. Cheers, Henner

I have 5 rubber vehicle wheel stops that require holes drilled in concrete and coach screws through the wheel stops into plastic plugs. (materials supplied) a rotary hammer drill is required. I have an aluminum pergola roof that needs brackets to be attached with metal screws to hold the roof battens to the joists. Brackets, screws and paint supplied. A cordless drill/driver and small step ladder is required.

Semi retired builder wanted to provide on going advice for building renovation ,

There is an existing extension that needs to be demolished and rebuilt.

4m x 2m Luxi Living Manual Louvre Pergola. Have all the parts and instructions, just no time to construct myself. Can help where two people are required, lifting etc.

Urgent or appreciated if can be done asap. Please go into the Sydney Botanical Gardens to the Herb Garden Pavillion Lawn and measure the distance between the sandstone pillars along with height. Measurements required: (the two pillars facing the large set of stairs ) 1- From inside edge to inner edge from pillars facing the stairs ( the distance between the pillars 2- The distance between the centre point of the pillars ( find the halfway or middle point from one pillar and measure to the halfway point of the other pillar. 3- Meaure from the outer most edge of the pillar to the outer most edge of the other pillar. 4- Measure the height from ground to the lowest point of the beige wooden timber facade at the top of the pergola between the pillars 5- measure the height from the ground to above the beige wooden facade between the pillars ( to the green wooden timber point) Please write down and take photos of the measurements, also double check these measurements are correct. I can provide further instructions and photos should you need any assistance.

Build a mosquito net enclosure for a portion of my balcony (4.5m length 1.15m width). I need the enclosure to be removable if necessary but routinely remain in place. It needs to cover all the gaps (as photographed) to ensure mosquitos can't get through. Budget is not including expenses for materials. - Due date: Flexible