Find trusted local electricians in Inner South Melbourne

We recently got ducted air-conditioning installed but we still have a split system in the wall upstairs however they disconnected the power when installing the new ducted unit. The clan was we were gonna get rid of it but we actually want to reconnect it and start using it again. We need a qualified electrician to reconnect the power to the unit. *Open to offers.

Installation of 4 new split systems AC units. 3 x 2.5kw to bedrooms. 1-7.2 kw to living room. We will supply all the AC units so install and elec power from main power board in garage to units required. All outdoor units can be located on ground floor roof or wall adjacent each room. Needs Power. Need to supply compliance

Install new air con split system in small bedroom downstairs- easy access to outside wall (2.6 inverter reverse cycle Hyundai brand) Back to back install on single brick wall ground floor

Looking for a qualified electrician to complete a few electrical jobs at our home: Relocate existing outdoor power point near front gate slightly back from its current position and replace with a double power point. Existing underground electrical cabling is already in place. Install approximately 2-3 new power points inside the house. Replace an existing garage light fitting with a new light fixture. Potentially replace an existing bedroom ceiling fan with a new ceiling fan. Please provide a quote for the above work.

Install outdoor rated dual power point, must be rated to support 1800W. Existing power point is available, installation height around 2.5-3m.

I was wondering if an electrician was able to install a 7kw EV charger here at my Chelsea Heights home. The power box is located at the front right of the house and Id like the charger located in the garage. Please see attached photograph. Thanks

Replace 2 pendant lights above dinning room table. Relocate so centred above table

Need a solar powered sensor light mounted

I need my bathroom ceiling fan changed. The fan size at the moment is 200 we’re going to be getting a 250 ceiling fan to replace the old one. You will need to cut the plaster and the fan has also been painted on.

I’m looking for a licensed electrician to complete a small electrical job: • Replace 4 existing light transformers • Replace 1 hard-wired smoke detector The existing lights and wiring are already in place, so this should be a relatively straightforward replacement job. Ideally looking for someone who: * Is fully licensed and qualified in Victoria * Can supply the required replacement parts or advise me what to purchase * Can complete the job in one visit * Provides any required electrical safety documentation on completion Please quote your best all-inclusive price, including labour and any call-out fee. I’m happy to be flexible with timing for the right person. If you’re already working in the area and can fit this in while nearby, that would be great. Thanks!

Hi There We need a licensed electrician to reinstall a ceiling light which we have stored. Photos attached are the hole where the ceiling light is and the type of ceiling light that needs installing. Thanks

Remove existing hanging light (large ball) and replace with new fitting. Certificate of work required

One PowerPoint is buzzing and needs replacing, we have a replacement. A second outdoor PowerPoint needs replacing as when one side is off it appears to still be able to be used.

1. Relocate 1x Light Switch: Move an existing light switch to a new location on the same/adjacent wall. Requires extending the wiring safely through the wall cavity. 2. Install 2x RJ45 Sockets: Install two network data outlets on separate walls within the same room and run/terminate the connecting cable (Cat6 or Cat6a)

Daikin won't turn on. Long beep on U4 code

Need 4 Power points run in a new workshop. Mezzanine level is exposed, so minimal drilling etc. 3 x 4 outlet GPO and 1 x 2 outlet. About 10 metres of conduit. 2 separate circuits with RGB etc. Plenty space in the fuse box. Happy with an apprentice etc.

I've got a hone wall EV charger, would like to install it inside my garage. Property is part of a townhouse, but I have my own electrical box control point inside the garage so hopefully it's a straightforward process? I have the charger already, just need to install

Lighting circuit keeps tripping, find fault and fix. I also have a motion sensor which requires replacing and 2 cut wires that need to be repaired. Ideally this is completed on an hourly rate