Find trusted local electricians in Moorabbin

Iam looking for electrician to put two down lights and replace an exhaust fan in bathroom and one in toilet

Can you take a permanent supply from the existing downlight circuit and install a concealed 12V/24V LED driver and timer to run three 1-metre LED strips independently of the downlight switch

Looking for a licensed electrician to complete the following: 1. Install 5 new power points at various locations around the house. 2. Cut/tidy an internal NBN/data cable and fit a cover plate over the opening. Materials • I will supply the 5 power points and cover plate. • Electrician to supply all required electrical cable, connectors, consumables, tools and other minor installation materials. Airtasker budget is for the onsite call-out/inspection only. Please inspect the locations, confirm what work is required and provide a separate quote for the full job.

I need to install New Stiebel Eltron 302L Hot Water Heat Pump System

Installation of about 30 downlights and powerpoints Must be licensed

Need a light put into a training room as well as 2 power points if possible

Looking for a licensed and certified electrician to install a new dedicated 15 amp outlet and circuit from the main switchboard. This is not a simple outlet change. A new 15A circuit with appropriate wiring and breaker will need to be installed. The work is required at two retail store locations in the Cheltenham or Brighton area. Please provide your quote and let me know what is required from my end to complete the job. Ideally looking to have this done on Monday, 9th March. If not available, please advise your availability. Thanks.

We have an existing broken intercom that we are looking to replace with a simple buzzer and remote unlocking capability. Power to the gate but it too has not been tested. The $40 fee is just a call out fee for the right person.

Old ceiling fan needs to be removed and new one installed.

need the pool heat pump connected. What’s already in place: • 32A breaker in the switchboard dedicated to the heat pump • 6mm cable already run from the breaker to the isolation switch • Isolation switch installed next to the pool equipment • Heat pump is in position Scope of work: • Open the isolation switch and confirm the 6mm feed is correctly terminated • Run the final connection from the isolation switch into the heat pump • Test the circuit to make sure it’s drawing correctly on the 32A breaker

To re-alight gas water heater. Anytime today or tomorrow

We would like fairy lights placed on the gutter of our house, along the side of the house & half way along the front. They are solar powered.

I’m looking for a painter or handy person who can help freshen up some signage and small areas inside our gym. What needs to be done: • Paint the outdoor overhead sign with paint that won’t peel (current paint is flaking) • Remove the indoor signs from the walls, repaint the wall under them cleanly • Paint the electrical conduits in the corner so everything matches and looks tidy • Supply all paint/materials within the $200 budget

Shop in Moorabin. I need a certified electrician to come in and give me a quote.

Hanging Light Shade Needs To Be Adjusted as per photo.

Flickering downlight in kitchen due to a faulty plug or socket. Budget is just a placeholder — not sure what this should cost, happy to receive fair offers

Remove existing CCTV, antenna, and NBN cables. Re-route and install new outlets on the opposite side of the living room. Install a new double power point on the same wall. Test all connections and leave the area clean and tidy upon completion.

Our wagons main 15 amp connection has reversed phasing, we need them swapped back around and then tag n tested for confirmation the wagon power is working as expected

We’ve recently purchased a dry food grinder machine and need a licensed electrician to safely connect it to power. The machine has already been assembled – we just need help with the electrical hookup. Details: Machine: Commercial dry food grinder Power: 63A, 400V, 50Hz (see photo for circuit breaker specs) Includes 2-pole breaker (CHSRME HL47-125) for connection Job involves wiring the machine to power through the circuit breaker or power plug.

Install conduit protection on wiring in garage