Find trusted local electricians in Caulfield South

Rewire existing garage keypad to new garage motor.

Have an issue with a light switch on a switch board when turning on flickering and hearing a loud electric noise. Commercial building

Plastic tabs on bayonette light fitting on ceiling broken and requires replacing. Just the 1.

We have birds nested on our double story solar panels, would like them removed and bird proofing put in please

Electrician to investigate tripping fault on Hot Water Boiler Circuit

I’m looking for an electrician to install 8 GU10 recessed downlights in a room I have already purchased: * 8 white GU10 gimbal downlight fittings * 8 GU10 smart bulbs * Double light switch The job involves: * installing the 8 downlights * replacing the switch * testing everything is working. The room is approximately 4.9 m × 3.1 m. I’d like 5 lights on one side of the room to highlight a feature wall, and 3 lights on the other side for normal room lighting. There is no roof access above this room, so please factor that into your quote. If possible, I’d appreciate pricing for: * all lights on one switch, and * the 5/3 layout on two switches. I’ve attached photos of the room, fittings and switch. Thanks.

I have a new cooktop and it has to be connected by a certified electrician

One of my smart light switches is not sending commands to the light, I can’t seem turn things on or off or reset. Would like for someone to come and have a look: If a replacement is needed, I have the switch too.

Replace Existing Downlights. Looking for a qualified/licensed electrician to remove & replace existing downlights in our home. Replace existing downlights with new fittings x 10 (pls supply). 8 x Kitchen & 2 x Bathroom. If required the roof accessible through attic ladder. Thanks!

I have an existing wired smoke alarm that needs replacing. as well as an outdoor wired spotlight

Only half the garden lights come on when turned on so think there may be some minor fault

I bought this pendant and would need to install at in my kitchen please https://www.aboutspace.net.au/products/caroline-white-single-pendant?country=AU&currency=AUD&gad_campaignid=23575746383&gad_source=1&gbraid=0AAAAADLh0tbnCaJFC2-LfND4HOG7OsZ-h&gclid=Cj0KCQjws83OBhD4ARIsACblj1-jgo7AI_xRhsagzkFOzBF4h2mZ9-LyDvh9YgzCjfyXWtT561IB0CsaAn_SEALw_wcB&tw_adid=&tw_campaign=23580718552&tw_kwdid=&tw_source=google&utm_campaign=sag_organic&utm_content=sag_organic&utm_medium=product_sync&utm_source=google&variant=43958052290669

Looking for a licensed electrician for a small outdoor job. Scope of work: • Install GPOs under the eaves outside • Wire them to an existing nearby indoor light switch so the outlet is switch-controlled • The outlet will be used to power two strings of outdoor festoon lights Access is straightforward (single story, roof access) and the switch location is very close to where the outlets would go. Location: South Caulfield Please let me know: • Your availability • An estimated cost (or if you prefer to quote on site) Thanks!

Replace two hardwired smoke alarm photoelectric lithium. Need issuance of COES. Single storey house.

Replace 4 led downlights

Licensed electrician with SAA battery accreditation required to install Sungrow battery (hardware supplied). Must provide all STC compliance paperwork. Please provide your accreditation and licence numbers.

We had a power outage last night and have woken to our front door hard wired intercom system flashing and making a continuous noise. Please see photo of the intercom I’ve included. I need someone to either fix it or disconnect it. We don’t use the system anymore so we’re happy to have it permanently disconnected if that’s easier.

Looking for a licensed electrician. Work required: Option A: Install and replace 2 ceiling light fittings and 2 wall light fittings to existing wiring points (wall lights mounted high on wall, ladder access required) Option B (optional): Install new dedicated 10-15 power point line in sink cupboard. Brick house from 70's Switchboard accessible inside entrance of house. I’d like pricing broken down (Option A only, and Option A + B), and advice on whether the 10-15A outlet is actually worthwhile for my use case before proceeding. Happy to provide photos and be flexible on timing.

We’re located in Ormond. Our house is a 1930s weatherboard, renovated in 1990s. Easy access to both below floor and into roof space. Want to check safety of generally wiring and possible disconnection to shed.

The unit is currently installed and needs to be safely disconnected from the power supply and removed. Any associated wiring should be made safe and compliant once the unit is taken out. Please let us know if patching or capping is required as part of the process, or if that would be handled separately. Access is straightforward, and we’re looking to have this done as soon as possible. If you can, please include availability and an estimate of cost.