Find a trusted local light installation service in Inner South Melbourne

Replace 5 ceiling lights with new lights, pics attached. Replace 2 ceiling lights not working with 2 of the removed lights. Replace 2 balcony lights with similar new ones, pics attached. Replace globes in one exterior floodlight and one garden low voltage light. We have all new lights and globes.

Needing someone to install and fix a light ox to the exterior of our building

Need a solar powered sensor light mounted

Hi There We need a licensed electrician to reinstall a ceiling light which we have stored. Photos attached are the hole where the ceiling light is and the type of ceiling light that needs installing. Thanks

Wanting to remove chandelier light fitting Replace with wicker uplight fitting Photos attached of existing and new light fittings Have globes ready

Replace Dimmable Light Switch I need a faulty dimmable light switch replaced. The switch has stopped working and the connected light is currently not functioning. The fuse/circuit breaker is on and appears to be working. Job requirements: • Diagnose/confirm the faulty dimmer switch • Supply a suitable replacement dimmable light switch (same as shown on picture) • Remove the existing switch and install the new one • Test the light and dimming function to ensure everything is working safely Please include the cost of the replacement switch in your quote.

Licensed electrician to replace ceiling fan with new IKEA light fixture. Ceiling approximately 3.5 m high, so please bring a suitable ladder. Updated offer. Thanks!

I have purchased an up/down light that I’m wanting installed at our front entry which is located under our carport

Extra power points in lounge room & split fan and light switch in upstairs in bathroom and also add dimmer. I need x4 extra power points and perhaps also upgrading one of the PowerPoints already existing under the TV to be upgraded to one including usb ports

Need some electrical work to be done around the house. Supply and install 2 new power points inside garage, internal cable run. Supply and install 1 new outdoor power point outside garage. Install 1 hex light inside garage. NXTBEAM 14 Bordered Hexagon / Honeycomb Lighting Kit - 4.8x2.4m. Remove and replace 1 indoor light. Install and ceiling reinforce 1 laundry electric airer.

I currently have 5 pendent lights in my house and need them replaced with new pendant lights I have purchased

1. Remove existing ceiling light, 2. Install new light

Need someone to install a dimmer as well as a new socket in our second bedroom

Replace 3 outdoor lights with new ones. I supply all new lights. Single storey house. Install a spotlight in garage. Pictures attached for all locations.

Hi seeking licensed electrician to repair or replace a light fitting with electrical certicate ( globe pushes in but doesn't hold ) with similar as possible - please include when you can do it - will accept first reasonable offer - thank you

Install lightweight XPS foam-based cornice 2 bedrooms 3x3 and corridor 1.1 x10 see link on how to install https://cornicestore.com.au/cornice-installation/

Hi there, I need to hire an electrician to install 2 new pedant lights and fix the downlights that’s not working

Looking for a practical handyman to install a lightweight side gate between two units in Hughesdale. The setup: -Gate and frame are already purchased and on site - One side has an existing panel/post to attach to - The other side needs a support — looking at a no-dig/concrete-free post from Bunnings (e.g. ground spike anchor) Measurements: Total fence to path width: 133cm Gate width: 78cm Side panel: 31cm Path width: 84cm Gate height: 120cm Back panel height: 124.5cm Front panel height: 124.5cm (approx.) What we need: Someone to assess, source a suitable ground spike or stake from Bunnings (nearby), and install the gate so it opens and closes securely. No concreting, no panels, no major earthworks. Goal: Keep a dog contained. Function over form — doesn’t need to look perfect. Budget is $200 all-inclusive (your time + any hardware). Happy to discuss if you have a smart, cost-effective approach. This is a job for a confident handyman, not a fencing contractor. If you’ve hung a gate before, this is right up your alley.

Hi, I’m looking for someone to install some lights in my bedroom. It comes with a remote so i would need that to work and to be connected to the switch as well. You will need to come with your own tools since I don’t have any. The last photo is the current light I have.

Need to drill a light box into a wall, and connect it to the light switch which is on the wall behind it on the inside