Find experienced local tradies in Morningside

Chippy/plasterer needed to remove the sheeting, put in new sheeting, put in new skirting and prep for painting. We will organise painter seperatly. Area is floor to ceiling in height, approximately 1.5meters length

This is my garage roof ceiling which was damaged by water. I would like the affected panels to be replaced please.

Removing a kitchen and need 5 power points cut and capped to remove cabinetry. Also need wiring for induction stove cut and capped

i need someone to come to my house and repair my ceiling in a linen cupboard post new aircon unit install. Using Gyprock ceiling tiles and appropriate frame max size is 2.1x2 want the job to include all materials

I have 3 small built in wardrobes that I want redone I would be open to either using ikea wardrobes or someone building them if they are a carpenter The week they need to built in is w/c 30th June

Balustrade needs sanding and prepping for primer and paint ! Just the left and right and up to balistrading. Top blistering is good

Recently took down 5 roof sheets after a hail storm. I’m after a handyman to install the new 5 sheets to my awning. I have had a delivery of the sheets and roofing screws. Everything will be provided (maybe you’ll need a bigger ladder as I only have a step ladder)

Install x2 TV's at Morningside

Fix a hole in a plasterboard wall made to replace bathroom fitting

Looking for a qualified carpenter with all the tools required to remove old balustrades and supply and install new outdoor deck balustrades (handrail, lower rail and balusters) with following dimensions. Handrail lengths: - 1x 1.7 m - 1x 1.71 m - 1x 1.48 m - 1x 1.36 m Baluster dimension: 82 cm x 6.2 cm x 2 cm 2 existing posts need to be cut and/or sanded down to be level with the top of the handrails. The handrails need to be level and top of the handrail should be flat as we are installing aluminium shutters directly on top of the handrails. No painting is required for this job, but the baluster cut ends including nail heads should be primed / sealed to avoid the balusters and lower rails from rotting. Job required to be done to a professional finish.

Hoping to find someone with experience in plastering to apply plaster to a section of wall in my kitchen. The area is about 1.7m2 and also has a section that needs to be filled in with mortar.

Require power point installed in oven cavity.. to replace hard wired oven. The oven isn't working, buying new oven with a pug in. Must be qualified electrician

Level Handrails (1 end of hand rail is 2cm lower than the other end). Repair or replace damage balustrades (Some pine balustrades are broken. Others are rotting at the bottom where they contact the bottom rail probably because the ends were not primed properly). Cut off top of balustrade posts to indicated mark. Baluster Handrail Lengths: - 2x 3.6m length - 2x 2.96m length No painting required.

Ground floor back deck awning requires drain and down pipe installation. Price reflects materials need to be purchased as well. More pics and measurements to come

Looking for someone who can dismantle a few walls. Leaving all the posts in place though (and not cut through any electrics). Remove bathtub, tiles, shower panel, and pasterboard. Behind the plasterboard is very original VJ wall (hardwood). Approx 3.6m width in the bathroom (height - Queenslander ceiling height). In the hallway remove the plasterboard, again leaving the posts. Not sure if hardwood behind that wall but if it is remove it there. We can take all the rubbish to the dump - just needs to be placed in the garage.

Power point prong got damaged in move and needs replacement.

i have a harvia sauna heater i need installing, i would also need a 15 amp plug.

Pine framed, plaster 3.2m x 1m balustrade to be removed at first floor level. From the house drawings the balustrade is attached at floor level and is a separate structure so should be easy to remove. Wall and stairwell wall to have plaster repaired (ideally but if you cannot do plaster that is OK). Need to have drop sheets and dustless tools if possible please. Connection to the floor can be left exposed as will need to figure out what is there and how to cover it once balustrade is gone. Please ask any questions.

One towel rail has come off bathroom wall. Need reattached and another three tightened. Require dents in plaster fixed and sanded. I have the paint so will paint once done.

Need a plasterer to patch holes in ceiling